two points,, first,,, that's a no gas mig welder you were using,, and not a tig welder!,, and two,, you never put an eye on the blade end for tripping the anchor if it ever get's stuck,, never fasten any anchor by the shank end,, doing this is a sure way of losing your anchor if it gets stuck in rock's!,, all ways fasten the anchor at the blade end using a shackle,, and then tie the chain onto the shaft end with a few cable ties,, should the anchor become stuck,, you drive over the top of the anchor thus braking the cable ties, and you pull the anchor free from the blade end,, (pulling the anchor out backwards!),, but its great video,, now I will make a few anchors myself!
two points,, first,,, that's a no gas mig welder you were using,, and not a tig welder!,, and two,, you never put an eye on the blade end for tripping the anchor if it ever get's stuck,, never fasten any anchor by the shank end,, doing this is a sure way of losing your anchor if it gets stuck in rock's!,, all ways fasten the anchor at the blade end using a shackle,, and then tie the chain onto the shaft end with a few cable ties,, should the anchor become stuck,, you drive over the top of the anchor thus braking the cable ties, and you pull the anchor free from the blade end,, (pulling the anchor out backwards!),, but its great video,, now I will make a few anchors myself!
Hi to make the anchor set faster you can use a length of chain to keep it on the ground which will make it bury faster 😁👍
That's true! I'll probably make an extra episode between episodes with such upgrades on the project! Thanks for the suggestion
@@matsudaindustries2530 Good idea 🙂
Nice
Well done.