Looks great! Definitely planning to order this once it’s available. Too bad it doesn’t have a thermometer on the heater, that would be cool to know how hot the water is just by looking at it
@@jrsanchez2517 Great question. I have it sitting in the cart and plan to put hade next month. Especially due to FOMO. However, I'd love to hear a response from RinseKit first.
@@JonnyBgooD007 How is the Pro pak holding up? Im planning on getting the Pro pak because of the insulation, so when i go camping during winter or cold days, in addition with the immersion heater, i'll have hot or warm water all the time.
@@jrsanchez2517 Amazing! Ive been in both kinds of weather you've mentioned. I did however have to send it back within the warranty date for a seam issue. The gasket that meets the top (inlet) had a tore at the seams. They quickly replaced it and it's much more reinforced. It's been going strong and I've had it since released.
The only solution I found is to waste all the cold water first. Then warm water comes. This bec the engineers forgot that warm water goes up and cold water down 😢. A floating pump would definitely be the solution. By now, only very few liters to get warm shower and liters of cold water wasted😢
Hey Rodney! It depends on the starting temperature of the water. The 12V plug heats the water in your RinseKit PRO approximately 13° Fahrenheit every hour, and the trailer hitch plug heats approximately 24° Fahrenheit every hour.
Man I’m highly disappointed I just purchased mine been trying to use it for 3 days now and not one time has the water reach over 100 degrees. First it takes forever to heat the water seconds it says it’s ready but it still shoots out cold water I tried spraying the water longer because maybe the water in the holes is just cold but that turned out to not be the case all the water was cold. I love my rinse kit one off the best purchase I ever made but this heater wasn’t it
Hi there! So sorry to hear your Immersion Heater isn't heating! Please fill out our warranty form so we can either replace or repair that for you. You can find the warranty form here: rinsekit.com/pages/rinsekit-warranty
@@Rinsekit I think you must have sent me the unit this guy sent back. I plugged it in, the light turned red, 20 mins later the light turned green and the water was the same temperature and the metal rod wasn't event slightly warm... What a waste of time.
Looks great! Definitely planning to order this once it’s available. Too bad it doesn’t have a thermometer on the heater, that would be cool to know how hot the water is just by looking at it
Duly noted 🤔
I'm a truck driver some places I don't even want to to use their shower if they had one truck driver's would love your product line.
Plug it into you 12v solar generator bam.
I have the 4.5 pro pak. Love mine! With that said, what the estimated time it takes to heat the water using this kit via 12v plug?
So did you get one for your Pro pak? And if so, how do you like it?
@@jrsanchez2517 Great question. I have it sitting in the cart and plan to put hade next month. Especially due to FOMO. However, I'd love to hear a response from RinseKit first.
@@JonnyBgooD007 How is the Pro pak holding up? Im planning on getting the Pro pak because of the insulation, so when i go camping during winter or cold days, in addition with the immersion heater, i'll have hot or warm water all the time.
@@jrsanchez2517 Amazing! Ive been in both kinds of weather you've mentioned. I did however have to send it back within the warranty date for a seam issue. The gasket that meets the top (inlet) had a tore at the seams. They quickly replaced it and it's much more reinforced. It's been going strong and I've had it since released.
Time water takes to reach various temperatures not mentioned?
It will be great if there was a way to hard wire it to a power system in a van
Are you able to plug into a battery system, like jackery, and let it sit and heat up the water inside the RinseKit pro? Thank you
It uses A LOT of power.
Mine did not heat up enough after the light turned green. Can I unplug it and plug it back in to heat it more?
Any update on this? Having same problem.
Same here
The only solution I found is to waste all the cold water first. Then warm water comes. This bec the engineers forgot that warm water goes up and cold water down 😢. A floating pump would definitely be the solution. By now, only very few liters to get warm shower and liters of cold water wasted😢
How many AMPS does the 12V CIG lighter use? Most cars are limited to 100W or about 9amps. And the solar generators like Jackery are 12v & 10amps max.
How long does it take to heat the water to shower temperature?
Hey Rodney! It depends on the starting temperature of the water. The 12V plug heats the water in your RinseKit PRO approximately 13° Fahrenheit every hour, and the trailer hitch plug heats approximately 24° Fahrenheit every hour.
Man I’m highly disappointed I just purchased mine been trying to use it for 3 days now and not one time has the water reach over 100 degrees. First it takes forever to heat the water seconds it says it’s ready but it still shoots out cold water I tried spraying the water longer because maybe the water in the holes is just cold but that turned out to not be the case all the water was cold. I love my rinse kit one off the best purchase I ever made but this heater wasn’t it
Hi there! So sorry to hear your Immersion Heater isn't heating! Please fill out our warranty form so we can either replace or repair that for you. You can find the warranty form here: rinsekit.com/pages/rinsekit-warranty
@@Rinsekit I think you must have sent me the unit this guy sent back. I plugged it in, the light turned red, 20 mins later the light turned green and the water was the same temperature and the metal rod wasn't event slightly warm... What a waste of time.
Will this work with the rinsekit cube?
It only works with the PRO, but the HyperHeater will work with the Cube!
Does not work with Tesla's that have low voltage lithium-ion batteries, check Tesla's manual.
My Tesla also has a trailer plug so wondering if it'll work with that