Thank you so much for the help . I am using the NX8 but i am assuming it is the same setup. i used C channel for as you did yours but used high ,mid and low instead of high and low. if there is a difference using the NX8 please let me know thanks again
Hello. Need you help please :) I bought the PNP version (EFL08975) (I use FrSky radio/receiver), but the user manual available always refers to the BNF version (EFL089500). My question is :what is the mix Flaps/Elevator to do ? As per the manuel (and my understanding....), flap Pos1 is 30mm, Pos2 is 60mm. But what about the elevator ? thx
Good job guys, thanks 👍🏻
Thank you so much for the help . I am using the NX8 but i am assuming it is the same setup. i used C channel for as you did yours but used high ,mid and low instead of high and low. if there is a difference using the NX8 please let me know thanks again
Thanks this helps a lot!
Hello. Need you help please :)
I bought the PNP version (EFL08975) (I use FrSky radio/receiver), but the user manual available always refers to the BNF version (EFL089500). My question is :what is the mix Flaps/Elevator to do ?
As per the manuel (and my understanding....), flap Pos1 is 30mm, Pos2 is 60mm. But what about the elevator ?
thx
Crappy setup. You didn't even go through forward programming!!!