at 8:50, you said all solid edge wiring harness comes included with electrical parts library. But I couldn't find it in the software, how to find and use it? Please guide.
Hello Dipankar and thank you for your question. I will try and keep my answer as simple as possible. The answer is yes, the embedded electrical parts library (including electrical parts and symbols) is included in every install of the Solid Edge wire and/ or harness design (they can be purchased and run independently of each other based on your need). The administration of the library is configurable at the installation process. Once you accept the license agreement and determine whether you are installing a "complete" (one tier - stand alone) or a "custom" (two-tier - network) installation type, you will determine the location of the parts library (called the embedded database) to be installed. Once installed and you are in the application, you can access and configure the parts & symbols library directly from the launch button within the solid edge electrical application how you wish. If you have any further questions, please contact us at technical.support@prolim.com for additional information. Thanks, Aaron
At 41:14 there was a simulation between two grounds (Where should not be a potential difference normally). The two grounds were not on the same net I presume. How can you place multiple ground symbols(preferably across sheets) in a way that they are part of the same net? Similarly to references. (but with visually representing ground symbols)?
![FNAF vs TF2 - Episode 2 [SFM]](http://i.ytimg.com/vi/z5b3V2-VLb0/mqdefault.jpg)
Good Designed 👌
at 8:50, you said all solid edge wiring harness comes included with electrical parts library. But I couldn't find it in the software, how to find and use it? Please guide.
Hello Dipankar and thank you for your question.
I will try and keep my answer as simple as possible. The answer is yes, the embedded electrical parts library (including electrical parts and symbols) is included in every install of the Solid Edge wire and/ or harness design (they can be purchased and run independently of each other based on your need).
The administration of the library is configurable at the installation process. Once you accept the license agreement and determine whether you are installing a "complete" (one tier - stand alone) or a "custom" (two-tier - network) installation type, you will determine the location of the parts library (called the embedded database) to be installed. Once installed and you are in the application, you can access and configure the parts & symbols library directly from the launch button within the solid edge electrical application how you wish.
If you have any further questions, please contact us at technical.support@prolim.com for additional information.
Thanks,
Aaron
At 41:14 there was a simulation between two grounds (Where should not be a potential difference normally).
The two grounds were not on the same net I presume.
How can you place multiple ground symbols(preferably across sheets) in a way that they are part of the same net? Similarly to references. (but with visually representing ground symbols)?