In this video I show you how to replace a Yamaha Blaster stator or flywheel. Like, Comment, Subscribe, And Turn Off Post Notifications! Instagram: FullThrottleProductionss
I replaced my stator and when I put the new one the magneto won’t spin..I lined it up with the key but then it feels like it’s stuck. Any ideas why? It used to spin with the old stator so I’m not sure if I’m installing it wrong
@@isaacbaas9509 yo wassup I just seen this comment , I just bought a new stator that I could adjust and lined it up with the old one and marked it , it u can print out a timing sheet online then you need to torque the flywheel , if it’s not torqued right the stator will burn
My flywheel is covered in some powder orso, kinda yellow ish, any idea?
Rust maybe?
What coil is the lights coil?
I replaced my stator and when I put the new one the magneto won’t spin..I lined it up with the key but then it feels like it’s stuck. Any ideas why? It used to spin with the old stator so I’m not sure if I’m installing it wrong
Are you sure the screws holding the stator plate are seated down all the way? They will bite the back of the magneto and not let it spin.
I put a new stator on now the bike is going in reverse I can’t do the timing cause it only bolts in 1 wat
Same man same
If you figure it out lmk😂
That means you need to reverse the polarity of the stator, snip + and - and swap them. Will require some soldering to do it the right way.
@@isaacbaas9509 yo wassup I just seen this comment , I just bought a new stator that I could adjust and lined it up with the old one and marked it , it u can print out a timing sheet online then you need to torque the flywheel , if it’s not torqued right the stator will burn
Look like a rx king motorcycle the all ignition...cool...