We have issue with that NaturalDry system that opens the door at the end of cycle. Today door opened but that plestic rod that pushes door is not retracting back. For some reasin it is stuck in OUT position. After ON/OFF or unplug from socket we are still stuck with useless dishwasher.....
Hi Sir, apology for this. Please have a call for us so we could assist you. For urgent concerns, you may contact us at our service hotline: (02) 8230-1555 local 8300-8314 / 0917-8696111 / 0925-7372477.
@@edaunlu3756 What ive done: Pulled the dishwasher out just to be able to gain access to the top part. Then removed all screws that hold that motor on top of the dishwasher. This little motor pushes the door open at the end of the cycle. Next I removed that motor from its position. Did not disconnect wires, just leave it hanging. Close the door and start any washing program. Let it run till the end and that motor actuator will retract to normal position. Thwn just put all back with screws. Hope this will help you.
Connecting the inlet hose to the water source is the most difficult part of installation. Can't find anything about this in the internet especially for this model.
Hi, we suggest install the unit on the floor, since this is a free standing dishwasher. For installation For urgent concerns, you may contact us at our service hotline: (02) 8230-1555 local 8300-8314 / 0917-8696111 / 0925-7372477.
@@ChristianWagner888 my dishwasher, this model in the video, lasted 4 years. It has a non-stop warning about No Water Tap available, I've checked water pressure, clogs, even changed the water inlet with a brand new, and problem persists... My previous dishwasher was also a Whirlpool, it lasted 5 years until de controller board died.
@@mogwairider2766 thanks for sharing your experiences! That leaves us with few reasonable choices in the Philippines. Whirlpool is the only dishwasher brand that has some international sales of the same model. All others seem to be no-name Chinese brands that might break down after 6 weeks or 6 months with unknown service accessibility even during the nominal 1 year warranty.
Hello@@ChristianWagner888, just fixed the dishwasher. It was the water level sensor that was stucked. It started working after cleaning inside. if anyone has this problem, in this dishwasher the water level sensor is on the left side of the machine, and the water valve is on the back.
Be careful. The instructions says add water to the salt place for first time only. After filling is with water add the salt….
I saw no mention of levelling on this installation instruction.
We have issue with that NaturalDry system that opens the door at the end of cycle. Today door opened but that plestic rod that pushes door is not retracting back. For some reasin it is stuck in OUT position. After ON/OFF or unplug from socket we are still stuck with useless dishwasher.....
Hi Sir, apology for this. Please have a call for us so we could assist you.
For urgent concerns, you may contact us at our service hotline: (02) 8230-1555 local 8300-8314 / 0917-8696111 / 0925-7372477.
I have this problem now, what did they do? I need help
@@edaunlu3756 What ive done:
Pulled the dishwasher out just to be able to gain access to the top part. Then removed all screws that hold that motor on top of the dishwasher. This little motor pushes the door open at the end of the cycle. Next I removed that motor from its position. Did not disconnect wires, just leave it hanging. Close the door and start any washing program. Let it run till the end and that motor actuator will retract to normal position. Thwn just put all back with screws.
Hope this will help you.
@@krivickas i will try thankyou, its a big issue i hope it will work
@@edaunlu3756 the fix is easy. If you have whirlpool dishwasher and its same issue then must work.
Hello, please how do you set water softener? Or is it automatically set? Thanks
Bonjour pourriez vous faire un tuto pour adapter les paniers en hauteur ou inversement Merci
Hi my new whirlpool dishwasher after starting in only 5 min it shows end how to fix the problem
Thank you nice demo.
Anyone, please let me know how to exit demo mode on this machine. Thank you.
Is your unit on demo mode? Please reach us on Facebook (Whirlpool) Kindly message us
I realised, if the drain outlet is not more than half height of the washer, it doesn’t work.
Yes it should be at least the height of he dishwasher
Connecting the inlet hose to the water source is the most difficult part of installation. Can't find anything about this in the internet especially for this model.
Why, it's just a water tube
For urgent concerns, you may contact us at our service hotline: (02) 8230-1555 local 8300-8314 / 0917-8696111 / 0925-7372477.
Can i not use the salt at all?
Hi, for this kind of dishwasher it is important to use dishwashing salt.. you cannot use the dishwashing if you will not put salt in it..
Does it need to water heater to work
Do i have to remove the styrofoam that is placed inside the dishwasher when I remove the top?
Same question
Can I use regular table salt in this machine?
no you cant. as the salt to use in this is what we call dishwashing salt.. Intended for filtering lime scale of the water..
where can I buy that specialized salt? I just bought a Whirlpool dishwasher@@exatechapplianceandservices
It had worked only 5 years and had broken (((
Does it have wheels
There is no wheel on the unit. Thank You
Su aldığı halde neden çalışmıyor
Can I put this on counter top
Hi, we suggest install the unit on the floor, since this is a free standing dishwasher.
For installation For urgent concerns, you may contact us at our service hotline: (02) 8230-1555 local 8300-8314 / 0917-8696111 / 0925-7372477.
Link dijiye discription main pliz
www.whirlpool.com.ph/wfc-3c26.html?gclid=CjwKCAiA_omPBhBBEiwAcg7smSv7-TCuVUAkACmA0tAu-Van2UO2uPUsZ3ckoZD2oHEBFlmu3R773hoCKToQAvD_BwE
Washes well but dosen't last more than a couple of years.
HI, As long as you properly use the unit there will be no problem. Thank You
A dishwasher should last for about 10 years. Whirlpool is supposedly decent brand...
Why do you think this model will not last long?
@@ChristianWagner888 my dishwasher, this model in the video, lasted 4 years. It has a non-stop warning about No Water Tap available, I've checked water pressure, clogs, even changed the water inlet with a brand new, and problem persists... My previous dishwasher was also a Whirlpool, it lasted 5 years until de controller board died.
@@mogwairider2766 thanks for sharing your experiences! That leaves us with few reasonable choices in the Philippines. Whirlpool is the only dishwasher brand that has some international sales of the same model. All others seem to be no-name Chinese brands that might break down after 6 weeks or 6 months with unknown service accessibility even during the nominal 1 year warranty.
Hello@@ChristianWagner888, just fixed the dishwasher. It was the water level sensor that was stucked. It started working after cleaning inside. if anyone has this problem, in this dishwasher the water level sensor is on the left side of the machine, and the water valve is on the back.
Prize kitni hai
www.whirlpool.com.ph/wfc-3c26.html?gclid=CjwKCAiA_omPBhBBEiwAcg7smSv7-TCuVUAkACmA0tAu-Van2UO2uPUsZ3ckoZD2oHEBFlmu3R773hoCKToQAvD_BwE
Super,ok
Thank You
Mining F1