Thanx for the video. I just used a puller and a small plumbers torch to pull the tone ring. How much grease are you supposed to pack inside the rotor and how did you reinstall the tone ring?
I did no see this till now, we did it this AM. I filled it about 1/3 of the way full. My buddy had me use Edelbrock's Gasgacinch #9300 on the outside edge of the seal, it worked well. Were going to do the DS tomorrow, I will try to take a pic of the puller I am using to pull the tone ring. Before I reinstalled the tone ring this AM I placed the cleaned tone ring in an oven set at 200 degrees. It dropped on w/ little persuasion w/ a brass drift punch and hammer.
Thank You very much for this Video. It has given me the knowledge I needed for a job I'm going to do tomorrow.
Thanx for the video. I just used a puller and a small plumbers torch to pull the tone ring. How much grease are you supposed to pack inside the rotor and how did you reinstall the tone ring?
Hi..ArtisannasitrA. Don't pack it full -- about 50 percent grease is plenty .... to reinstall it I i use a hard piece of wood
I did no see this till now, we did it this AM. I filled it about 1/3 of the way full. My buddy had me use Edelbrock's Gasgacinch #9300 on the outside edge of the seal, it worked well. Were going to do the DS tomorrow, I will try to take a pic of the puller I am using to pull the tone ring. Before I reinstalled the tone ring this AM I placed the cleaned tone ring in an oven set at 200 degrees. It dropped on w/ little persuasion w/ a brass drift punch and hammer.
Nice job on the video. Thanks.
I love my raza . . . no matter what! . . .we get it done!
Cuanto torquea el caliper y las tuercas del rin? Buen jale
Nice. It helped thanks
Nice
How did you get the gear thing off behind the rotor
Thankyou
a big help
good