Hi what is the fonction of the ctrl HSC bloc exactly ?? because u already used in input "id1000" which u convert to real to get the right value , i'm okay with dat but eh ctrl hsc fonction ??
HSC is the control block. It controls many functions such as starting the encoder pulse and resetting the current value. If you have no knowledge about this subject, you should get training!!!🙃
@@mertsenay3105 Its doesn't answer my question , i can use a normal counter to count pulse and use comparaison bloc to reset the counter when i want , so why i will use this bloc for encoder ??
i found one big problem in this if you're reading in point due to calculation after point motor will not stop to value format change after pointing you are use equal block so required and giving reading sometime not same so how to change format before i done but now did not find in TIA portal
Encoder ou a relação de polias dele percorre 15mm com 5000 pulsos do encoder... Divide 15/5000= 0,003mm com 1 pulso... Depois ele multiplica numero de pulsos gerados pelo valor de 1 pulso em mm. Super básico..
I am using axis position in TIA PORTAL using motion control block I want to read axis position in retentive range What is method for it Currently i am using move block and acis actual position But it is not retentive Is there any special instructions block for it..?
Thank you for the video.
Hi what is the fonction of the ctrl HSC bloc exactly ?? because u already used in input "id1000" which u convert to real to get the right value , i'm okay with dat but eh ctrl hsc fonction ??
HSC is the control block. It controls many functions such as starting the encoder pulse and resetting the current value. If you have no knowledge about this subject, you should get training!!!🙃
@@mertsenay3105 Its doesn't answer my question , i can use a normal counter to count pulse and use comparaison bloc to reset the counter when i want , so why i will use this bloc for encoder ??
Gracias
i found one big problem in this if you're reading in point due to calculation after point motor will not stop to value format change after pointing you are use equal block so required and giving reading sometime not same so how to change format before i done but now did not find in TIA portal
i need type of the encodor
Hello Can this program done on a simulator??
Hi, Any answer you got for this? Anywhere?
@@hemadeepan644 i found out it cannot be done on a simulator.
@@emmanuelohida752 Thank you
Hi may I know the value in the FB DIV 15.0 and 5000.0 stand for what?
Encoder ou a relação de polias dele percorre 15mm com 5000 pulsos do encoder...
Divide 15/5000= 0,003mm com 1 pulso...
Depois ele multiplica numero de pulsos gerados pelo valor de 1 pulso em mm.
Super básico..
Please clear 15/5000 is shaft diameter/resolution or
Shaft Circumference/Resolution
I am using axis position in TIA PORTAL using motion control block
I want to read axis position in retentive range
What is method for it
Currently i am using move block and acis actual position
But it is not retentive
Is there any special instructions block for it..?
its you make by grater then and lower then by this
What's formula 15 /5000?can you explain please
shaft diameter vs P/R
@@wilkerman2440Please clear 15/5000 it is shaft diameter/resolution or
Shaft Circumference/Resolution
@@mohammadmobin6971 Shaft diameter/Pulse per round
@@wilkerman2440Thank You
5 minits just open the program soooooo bad