Wrong. The new bushing when pressed down was deformed by material being carved out from the bushing. That's not the way to replace these bushings. Terrible example to "teach" here in youtube.
When I install a new wrist pin bushing ring it needs to be tight ?.I was reffering to the pin bushing alone and not about the oil gap between the pin bushing and the shaft.
@@MayoCarsDR Hello . I was reffering to the pin bushing alone and not about the oil gap between the pin bushing and the shaft. When I install a new wrist pin bushing ring it needs to be tight ?.
Hola hermano, estoy tratando de hacer este mismo trabajo, pero no tengo prensa, así que quiero hacerlo con un tornillo y una tuerca, crees que sea posible??? Saludos desde México!!
Wrong. The new bushing when pressed down was deformed by material being carved out from the bushing. That's not the way to replace these bushings. Terrible example to "teach" here in youtube.
Thanks for comment
When I install a new wrist pin bushing ring it needs to be tight ?.I was reffering to the pin bushing alone and not about the oil gap between the pin bushing and the shaft.
Seems to be a lot of material lost from the od of the bush when pressing the first one in.
The finger reem made me laugh too.
If you don't finger ream, how is she going to... oh, never mind!!
Looked like a monkey F'ng a football!!
Measure the OD of the wrist pin and the ID of the new bushing darn it!
so the pin bushings must become perfectelly tight inside the hole ???
No
The pin should neither be too tight nor too loose
@@MayoCarsDR Hello . I was reffering to the pin bushing alone and not about the oil gap between the pin bushing and the shaft. When I install a new wrist pin bushing ring it needs to be tight ?.
The music makes me want to swing from a shower curtain rod by a belt!!
Royalty-free music is like that. There is a way to defeat that feeling, the volume off button.
Hi man, I have a quick question. Do you know what pin bushings you used or numbers and where I can find them?
Hola hermano, estoy tratando de hacer este mismo trabajo, pero no tengo prensa, así que quiero hacerlo con un tornillo y una tuerca, crees que sea posible??? Saludos desde México!!
Can I use the same method to replace a bent wrist pin?
Yes
What tools are needed to complete this installation
All of them.
Sockets and a dead blow mallet!!
I though Barum Engines was bad, but............
Master you are perfect
Owusu Maxwell Thank you for comment 😀
this was hard to watch😂
1 zz everything
1zz engine rebuild ruclips.net/video/hP6ZkQzVJlc/видео.html
Nice
Good job
Uneven heating.. No Bueno senôr
Doesn't really make a difference.. after just a minute of pulling it off the heat, itll even itself out.
What's the sand paper do?
makes it unsmooth to promote better oil flow, and to endure a better fit if the bushing isnt allowing the pin to move freely.
It does a really good job of turning a cylinder into an hour glass or a beer barrel shape, hopefully an oval as well, for that little extra.