Размер видео: 1280 X 720853 X 480640 X 360
Показать панель управления
Автовоспроизведение
Автоповтор
Thanks! Looking forward to the factory LS compressor setup video.
AC is a must. 👍
Is that factory condenser
Yes factory c10 condenser
Dude nice! Anyone, Help help help! Im running a SD7B10 E SANDEN compressor on a 1984 c10 and just need the retro fit lines so I can use my original condenser and dryer thanks !
What ac compressor and mounting racket are you using?
The kit is from lssimple.net
Hey brotha what part of Central Valley are you from? I’m out of Fresno county and I’m looking for someone to lower my 85 C30 dually
I’m about a 1 hr drive outside of Fresno
@@bacfab9259 I’m also one hour outside of Fresno. I’m in Reedley
@@darrylrosales1366 shop is located in orange cove
@@bacfab9259 no shit! Whats the shops name? I’m looking to do some work on my C30
@@darrylrosales1366 Bryan’s auto center
Why don't you just recrimp the lines? A hand held hydraulic crimper would more than pay for itself in no time.
The tube diameters are different so this was the easiest way without ordering new fittings and it’s low cost
Thanks! Looking forward to the factory LS compressor setup video.
AC is a must. 👍
Is that factory condenser
Yes factory c10 condenser
Dude nice! Anyone, Help help help! Im running a SD7B10 E SANDEN compressor on a 1984 c10 and just need the retro fit lines so I can use my original condenser and dryer thanks !
What ac compressor and mounting racket are you using?
The kit is from lssimple.net
Hey brotha what part of Central Valley are you from? I’m out of Fresno county and I’m looking for someone to lower my 85 C30 dually
I’m about a 1 hr drive outside of Fresno
@@bacfab9259 I’m also one hour outside of Fresno. I’m in Reedley
@@darrylrosales1366 shop is located in orange cove
@@bacfab9259 no shit! Whats the shops name? I’m looking to do some work on my C30
@@darrylrosales1366 Bryan’s auto center
Why don't you just recrimp the lines? A hand held hydraulic crimper would more than pay for itself in no time.
The tube diameters are different so this was the easiest way without ordering new fittings and it’s low cost