@@jtwad probably not. Holding the brake down at the same time I am not flooring it. I am just barely giving it gas. Just enough where I can fill the cart start to move
I commented on another video earlier and am currently going through the cart. Everything up until testing the ohms between the green and yellow wire I am good. My multimeters only show me OL when pedal isn’t depressed and it beeps and goes down to around 2 and continues going down. I ran a jumper wire from battery positive directly to the controller where the red wire was and it did the same thing.
I did the controller output test right after, and it shows voltage until I press the gas and then it shows about 20v compared to the 50ish V when pedal isn’t engaged
@heyheyhey97 First thanks for the videos you do the best working us through. I have a question if you get a moment. My ohms is 6.8 down to 1.8 when I press the peddle. It was 7.3 but I replaced the mcor . I suppose that means the controller is shot.
@6:30 of the video. I have battery voltage in but nothing out. The small red I get battery volt when I hit the pedal. And the homes between the yellow and green is over 6k about 6.3k and it drops to about 1.3 or so.
Great video. How can I test my v-glide? I have a 94 club card DS that has the controller and v-glide. When I push on the gas, it’ll do about 15 miles an hour then if I let off and push down the gas again it does about 22. They said the glide was bad so I bought a new one. It’s part number 1012016. I just hooked it up and now the cart doesn’t move at all. How can I test for this problem?
I checked and the wiper and it does go all the way up. I hooked up the old v-glide because I knew that one worked. After I hooked up the old one the cart still doesn’t move. I don’t know what happened.
Does the key switch make it won't charge too? Clubcar ds 48v has power to lights, horn, turn signals but no power to meter on dash and charger doesn't charge when plugged in.
@cpfans90 no it won't run, I took it for a ride like normal and when I got home put it on charge but didn't notice it it started charging or not, hour later I hopped on it to take my puppy for a short ride and it won't go. Check voltage at the batteries shows 50.8 volts as always.
If the golf cart won’t run. The charger won’t come on. Open your charger up and hook the two wires on the relay together. And your charger will start charging
@cpfans90 but that's not going to fix the golfcart, batteries are fully charged 50.8 volts, when I turn key switch on I have no power at the voltage gage and no clicking when I step on the go peddle, I'm resetting the obc (on board computer) now as I'm typing this
@@rnull2237 okay so the cart does have voltage. You can bypass the obc I will send you a link in this description. On how to by pass it to see if it’s bad.
Hey bud, I got an 04 CC DS that won't go in reverse. When I checked the ohm's, in forward it goes 5-0, in reverse is starts at around 10 and drops to 5. When I jump the green and white wires off the reverse micro switch, it goes forwards and backwards, and when I switch the forward and reverse cables on the back of the FNR switch, it'll go backwards, but not forward. Any idea what would cause that?
@budlightninja4167 on the green and white wire the white wire has a resistor tied into it then it goes into a black wire. Do away with the resistor if the solenoid does click in reverse. That’s why you have a high ohm reading. I just do away with them. all it does is halve speed for reverse.
@@HeyHeyHey97 I tested as you did and the voltage never dropped at each battery. I bought a new charger and I’m charging the batteries now. If I try and go, the cart shakes. Both directions. If I accelerate slowly, it does move forward, just slowly.
@@rhinooman no use now you said the voltage never dropped per each battery. Is that while you’re hitting the gas? Also, where are you getting the 38 V from?
Question what if the solenoid isn’t clicking at all just replaced it as my club car ds was not going reverse and sometimes it would go in forward. Replaced Mccor replaced fnr switch replaced solenoid and somewhere down line won’t click anymore
@@HeyHeyHey97 I have yellow and red The red side gets like .02 whether you push pedal or not black gives 50 all the other bigger wires on solenoid give 50 as well .
Thank you for this excellent video... Bypass OBC solved my problem 😎
Yes sir. Hit that like and subscribe button for me. I have over 100 videos on my page and list 2 new ones a week.
Will do.... Do you have the rear wheels off the ground of that cart when you're pressing the accelerator
@@jtwad probably not. Holding the brake down at the same time I am not flooring it. I am just barely giving it gas. Just enough where I can fill the cart start to move
Is the obc the red wire thats on the controller?
@@TheTeejam171 what year is your cart.
BEST video on RUclips for troubleshooting your golf cart 👍👍🫡
Where you from. Thanks for watching and commenting hit that like. Button for me.
Thanks 👍
I commented on another video earlier and am currently going through the cart. Everything up until testing the ohms between the green and yellow wire I am good. My multimeters only show me OL when pedal isn’t depressed and it beeps and goes down to around 2 and continues going down. I ran a jumper wire from battery positive directly to the controller where the red wire was and it did the same thing.
Drop your ohms reading down on the meter.
@@HeyHeyHey97Dang, I don’t think my multimeter can do that unfortunately
I did the controller output test right after, and it shows voltage until I press the gas and then it shows about 20v compared to the 50ish V when pedal isn’t engaged
@@tuckernorton6886 I’ll read your stuff again in about 1 hour. Then will tell you what to do
I uploaded a short to this youtube to show what is happening. Piece of crap is making me lose my mind 🤣
same electrical diagnostic on a newer club car precedent?
@@32srt32 what year.
@@32srt32 watch this. Club car precedent Won’t move
ruclips.net/video/N_YghhiXhsw/видео.html
@heyheyhey97
First thanks for the videos you do the best working us through. I have a question if you get a moment. My ohms is 6.8 down to 1.8 when I press the peddle. It was 7.3 but I replaced the mcor . I suppose that means the controller is shot.
@@davidturley3881 what does your cart do. And is it just like the video above
Not necessarily does the solenoid click? Also tell me what the cart is doing
@6:30 of the video. I have battery voltage in but nothing out. The small red I get battery volt when I hit the pedal. And the homes between the yellow and green is over 6k about 6.3k and it drops to about 1.3 or so.
Yes solenoid test good and clicks and it sometimes runs for just a little bit
@@davidturley3881okay when it doesn’t run does the solenoid engage at that time
Great video. How can I test my v-glide? I have a 94 club card DS that has the controller and v-glide. When I push on the gas, it’ll do about 15 miles an hour then if I let off and push down the gas again it does about 22. They said the glide was bad so I bought a new one. It’s part number 1012016. I just hooked it up and now the cart doesn’t move at all. How can I test for this problem?
When you hit the gas is the v glide wiper arm going all the way up. When you hit the gas
Great question, let me check tonight and I’ll let you know.
Did you get it figured out
I checked and the wiper and it does go all the way up. I hooked up the old v-glide because I knew that one worked. After I hooked up the old one the cart still doesn’t move. I don’t know what happened.
Have you tried jumping the solenoid to see if the cart runs
Does the key switch make it won't charge too? Clubcar ds 48v has power to lights, horn, turn signals but no power to meter on dash and charger doesn't charge when plugged in.
Does the golf cart run. Meaning can you turn the key in and hit the gas
@cpfans90 no it won't run, I took it for a ride like normal and when I got home put it on charge but didn't notice it it started charging or not, hour later I hopped on it to take my puppy for a short ride and it won't go. Check voltage at the batteries shows 50.8 volts as always.
If the golf cart won’t run. The charger won’t come on. Open your charger up and hook the two wires on the relay together. And your charger will start charging
@cpfans90 but that's not going to fix the golfcart, batteries are fully charged 50.8 volts, when I turn key switch on I have no power at the voltage gage and no clicking when I step on the go peddle, I'm resetting the obc (on board computer) now as I'm typing this
@@rnull2237 okay so the cart does have voltage. You can bypass the obc I will send you a link in this description. On how to by pass it to see if it’s bad.
Good video! Great information!
Thanks Jake. Hit that like button for me. Trying to get this video over 100 likes.
Hey bud,
I got an 04 CC DS that won't go in reverse. When I checked the ohm's, in forward it goes 5-0, in reverse is starts at around 10 and drops to 5. When I jump the green and white wires off the reverse micro switch, it goes forwards and backwards, and when I switch the forward and reverse cables on the back of the FNR switch, it'll go backwards, but not forward. Any idea what would cause that?
@@budlightninja4167 yes sir if you jump the microswitch. That means you bypassed it. Sounds like a bad microswitch
I put a whole new FNR switch with new micro switches in and still did the same exact thing. Could it be the vglide is bad?
@@budlightninja4167 when it doesn’t go reverse does the sol click
@budlightninja4167 on the green and white wire the white wire has a resistor tied into it then it goes into a black wire. Do away with the resistor if the solenoid does click in reverse. That’s why you have a high ohm reading. I just do away with them. all it does is halve speed for reverse.
@@HeyHeyHey97Gotcha. Sounds like that would be the problem then. That's why it would go full speed when bypassed. Thank you sir!!
Dope video!
Thanks man appreciate it. Hit that like button for me. Trying to get over 100 likes on this video
I've got 48v until I press the pedal and then it drops to 38v. New batteries and new cables except going to the OBC and the solenoid. Any suggestions?
@@rhinooman going to share a video with you test them like this and let me know what it shows
@@rhinooman Ezgo txt won’t move solenoid clicks
ruclips.net/video/IDwWDvl0JyM/видео.html
@@rhinooman watch that video and let me know now when you hit the gas it drops voltage on the main positive and main negative.
@@HeyHeyHey97 I tested as you did and the voltage never dropped at each battery. I bought a new charger and I’m charging the batteries now. If I try and go, the cart shakes. Both directions. If I accelerate slowly, it does move forward, just slowly.
@@rhinooman no use now you said the voltage never dropped per each battery. Is that while you’re hitting the gas? Also, where are you getting the 38 V from?
Question what if the solenoid isn’t clicking at all just replaced it as my club car ds was not going reverse and sometimes it would go in forward. Replaced Mccor replaced fnr switch replaced solenoid and somewhere down line won’t click anymore
@@dezirose6254 what year is your club car ds
@@HeyHeyHey97 2002
@@dezirose6254 what color wires do you have on small post on solenoid.
@@HeyHeyHey97 I have yellow and red
The red side gets like .02 whether you push pedal or not black gives 50 all the other bigger wires on solenoid give 50 as well .
@@dezirose6254 for the red wire you put black lead of meter on main negative and test with red lead in forwars