Thankyou. I just performed this exact replacement. Before I ripped into it I thought I'd quickly check RUclips for any guidance and found your video. I would have done exactly the same as you first did if I hadn't watched your video. This is the only part to have failed on my 7yr old Sportage, well done Kia.
Thanks for this - had the same problem with the rubber perishing, hadn't built up the courage to install the new part until I watched your video. Hardest bit was probably getting the old one out as the metal clips are hard to reach, in the end I just prised them off with a small screwdriver. Thanks again!
Great! Glad it helped!! I did the front window regulators and next I am going to do the rear wheel speed sensor. Those have been the only issues with the Kia
Wished I saw the video before I made the same mistake taking of the lower trim panel first LOL. Good information in just replacing the outer handle versus the whole assembly. Thanks!
Thank you for the video...Now to find someone that would be comfortable enough to try switching mine out. I have a 2017 Kia Sportage, what would I put in the search engine to get the right liftgate release handle? If you live in Florida, I'll come to you🙂🙂. Thank you in advance
My 2015 sportage trunk latch will not open externally, either manually or with FOB. All other doors lock / unlock normally. I can pop open the rear latch from the inside with a screwdriver. Will this repair the problem? Is the tail gate relay part of this replacement? The exterior latch assembly is in otherwise good shape. Thanks in advance!
Unfortunately no BUT it will show you how to remove the trim panels to get to that latch. Remember to remove the top panel first as it exposes screws to remove the remaining pieces
Need help on my 2011 Sportage. Cannot get automatic tailgate to work. I manually opened it, removed and replaced actuator but still does not open. The two interior lights in rear section go on when door opens; the two lights on the bottom of the tailgate do not. Just like the latch does not open. Have checked power , fuses etc and all checked out. Looking for assistance. Thanks, Jerry
The two lights not going on indicates a bad ground. I’d start there. Disconnect the switch and the actuator to confirm they aren’t shorting out ground.
I'm facing a somewhat similar problem in removing the hatch panels from an '09 Sportage to replace the hatch lock actuator. Any advice before attempting the surgery? Which fuse should I check to make sure it's good before doing the more involved panelectomy?
Unfortunately I am not familiar with that year to advise you properly. As far as fuses, check the door locks, accessories, and perhaps the remote ones. The manual might give a better indication. Let me know how it goes!
$375 at dealership to replace, labor and part included. $135 for the part. Thanks for the video. I stopped tearing into it after there seemed to be a different way. I'm wondering how the parts working out now that you used it for several months.
Oh no! Mine wasn’t stuck. Check the fuses to confirm power first. I didn’t see an emergency release like cars have but there should be an access panel to manipulate it open. Check RUclips for that. Sorry I can’t be of more service
I replaced my lift gate switch WITHOUT removing any of the inside trim, I removed the switch from the OUTSIDE with a flat head screwdriver, disconnected it, unscrewed the camera and removed the old piece, screwed the camera on the new piece and connected it. And again WITHOUT removing ANY of the inside trim, just four screws for the camera and a connector for the switch, payed $14 for switch on Ebay, so this guy is kind of wrong by telling you you have remove ALL the inside trim.
@@RonKnowsStuff yes, I used a flat head screwdriver, I wasn't worried about the damaging the old switch and knew the new one would just snap into place. Maybe I should have made a video of how to replace the switch without removing any of the inside panels, you state in your video that you paid around $135 for something at the dealer, what was that for,?? the only thing I purchased was the switch for $14 on ebay.
He also stated to mark the camera so you don't put it back backward, the camera only goes back in ONE way, IF you put the camera backward the maybe you should pay and have someone else change the switch, I also ffg don't know what he payed $135 for. As i stated before I only payed $14 for the switch on Ebay and WITHOUT removing ANY of the inside. panels.
Yeah, I realized that later - you really can’t put it in upside down. I’ll look at it again but I didn’t see an option to pry the camera out so it was easier and less damaging to remove the panels. PLUS it gave me great content for the channel LOL! Thanks for watching. Feedback is appreciated
Yeah. I addressed my mistake in the video. It would have been so much easier if I started it that way. It’s more clear in the short I did on the same topic. Thanks for watching!
Window regulator video ruclips.net/video/InB_GUCxhQw/видео.htmlfeature=shared
Thankyou. I just performed this exact replacement. Before I ripped into it I thought I'd quickly check RUclips for any guidance and found your video. I would have done exactly the same as you first did if I hadn't watched your video. This is the only part to have failed on my 7yr old Sportage, well done Kia.
Glad it helped. My 2017 just had the driver’s window regulator fail. Other than that, it’s been awesome. I’ll do a video on that soon.
Thanks for this - had the same problem with the rubber perishing, hadn't built up the courage to install the new part until I watched your video. Hardest bit was probably getting the old one out as the metal clips are hard to reach, in the end I just prised them off with a small screwdriver. Thanks again!
Great! Glad it helped!! I did the front window regulators and next I am going to do the rear wheel speed sensor. Those have been the only issues with the Kia
Wished I saw the video before I made the same mistake taking of the lower trim panel first LOL. Good information in just replacing the outer handle versus the whole assembly. Thanks!
Glad it was helpful. It sure saves a ton of money doing it yourself!
Let me tell you something, thank you a lot. This video has really helped me. God bless you.
Wow! Glad it helped!!! I hope God blesses you as well. Thanks!!
Thank you for the video...Now to find someone that would be comfortable enough to try switching mine out. I have a 2017 Kia Sportage, what would I put in the search engine to get the right liftgate release handle? If you live in Florida, I'll come to you🙂🙂. Thank you in advance
I went to Amazon and got it. Go to my channel, it has my email and I can give you more info
My 2015 sportage trunk latch will not open externally, either manually or with FOB. All other doors lock / unlock normally. I can pop open the rear latch from the inside with a screwdriver. Will this repair the problem? Is the tail gate relay part of this replacement? The exterior latch assembly is in otherwise good shape. Thanks in advance!
Unfortunately no BUT it will show you how to remove the trim panels to get to that latch. Remember to remove the top panel first as it exposes screws to remove the remaining pieces
Do you know where there tail gate relay is located? Thanks again...great video.@@RonKnowsStuff
@@Stretch01 not for sure but I would start in the hatch itself. Be sure to check fuses first
Need help on my 2011 Sportage. Cannot get automatic tailgate to work. I manually opened it, removed and replaced actuator but still does not open. The two interior lights in rear section go on when door opens; the two lights on the bottom of the tailgate do not. Just like the latch does not open. Have checked power , fuses etc and all checked out. Looking for assistance. Thanks, Jerry
The two lights not going on indicates a bad ground. I’d start there. Disconnect the switch and the actuator to confirm they aren’t shorting out ground.
I'm facing a somewhat similar problem in removing the hatch panels from an '09 Sportage to replace the hatch lock actuator. Any advice before attempting the surgery? Which fuse should I check to make sure it's good before doing the more involved panelectomy?
Unfortunately I am not familiar with that year to advise you properly. As far as fuses, check the door locks, accessories, and perhaps the remote ones. The manual might give a better indication. Let me know how it goes!
Thank you for the video, hardest part was getting the old switch housing out 😂
Glad it helped! Only other issue II have 88,000 trouble free miles on it other than the window regulators.
$375 at dealership to replace, labor and part included. $135 for the part.
Thanks for the video. I stopped tearing into it after there seemed to be a different way.
I'm wondering how the parts working out now that you used it for several months.
ZERO issues! Have no fear buying it online.
I'm just wondering about the quality of the part.
@@JohnDoe-px6fz l am hoping it lasts longer than the original! Quality seemed fine. Fitment was perfect!
How can u open the hatch if its stuck from inside car hatch wont open
Oh no! Mine wasn’t stuck. Check the fuses to confirm power first. I didn’t see an emergency release like cars have but there should be an access panel to manipulate it open. Check RUclips for that. Sorry I can’t be of more service
Will replacing this piece fix a hatch that is supposed to be touchless but doesn’t work?
I’m sorry but I’m not familiar with the touchless option.
Where did you buy the part?
I got it on Amazon. Link is in the description
I replaced my lift gate switch WITHOUT removing any of the inside trim, I removed the switch from the OUTSIDE with a flat head screwdriver, disconnected it, unscrewed the camera and removed the old piece, screwed the camera on the new piece and connected it. And again WITHOUT removing ANY of the inside trim, just four screws for the camera and a connector for the switch, payed $14 for switch on Ebay, so this guy is kind of wrong by telling you you have remove ALL the inside trim.
So you used the screwdriver to pry it out? I didn’t see that as an option. Great score on eBay. I always forget to check there.
@@RonKnowsStuff yes, I used a flat head screwdriver, I wasn't worried about the damaging the old switch and knew the new one would just snap into place. Maybe I should have made a video of how to replace the switch without removing any of the inside panels, you state in your video that you paid around $135 for something at the dealer, what was that for,?? the only thing I purchased was the switch for $14 on ebay.
@@pysooners1855 I bought the driver’s door seal from the dealership. They way over charged. It was a moment of weakness!
Thank you sir!!!
Most welcome! Happy to be of service!
@@RonKnowsStuff I was in tears trying to figure it out on my own, God bless you!
@@fromthebayoulet me know if you need anything else
He also stated to mark the camera so you don't put it back backward, the camera only goes back in ONE way, IF you put the camera backward the maybe you should pay and have someone else change the switch, I also ffg don't know what he payed $135 for. As i stated before I only payed $14 for the switch on Ebay and WITHOUT removing ANY of the inside. panels.
Yeah, I realized that later - you really can’t put it in upside down. I’ll look at it again but I didn’t see an option to pry the camera out so it was easier and less damaging to remove the panels. PLUS it gave me great content for the channel LOL! Thanks for watching. Feedback is appreciated
You have opened trunk trim badly. Start with top trim unscrew to remove below trims
Yeah. I addressed my mistake in the video. It would have been so much easier if I started it that way. It’s more clear in the short I did on the same topic. Thanks for watching!
@@RonKnowsStuff did u break anything? I also learned the hard way.
@@omeriqbal6398 yes but not enough to notice or create rattles.
Please I have the same problem. I want to buy the lock. Can you send me the model number?
I replaced the video camera surround so I. Don’t have the model number for the lock. Be more specific and I’ll research for you
KIAs suck, I shoulda bought a toyota
I’m speaking from personal experiences and have had no real issues with the five I’ve own(Ed)