Shaft Alignment Part 1
HTML-код
- Опубликовано: 8 сен 2024
- This video is intended to guide a user through the shaft alignment process for a typical mid engine, direct drive tournament Ski Boat. Vee-Drive ski boats require additional steps and instruction. All Boat and Engine manufacturers recommend checking coupling alignment annually, and adjusted as needed.
NOTE: This video assumes that your boats strut is in good condition, a twisted, bent, improper factory strut installation will cause pre-mature bearing wear, and make alignment very difficult. If your shaft does not want to position itself in the center of the shaft log while holding the "heavy-end" up to compensate for the weight of the un-supported coupling end, you will need to address a strut problem. Feel free to call with these issues for assistance. (985) 542-4336 RonT
For all your ski boat part needs check out our webpage below
www.skiboatpar...
Like us on Facebook
/ skiboatpartsonline
These videos are not only very helpful but also well produced. We are in the middle of a bringing a 83’ Ski Nautique back to life. These videos have been invaluable for learning, planning and preparing. Well done.
that voodoo statement was pretty spot on lolol
Nice video. Precise expalnation with wider scope and tips from experince. Nice to watch and hear. Greetings from Poland.
Excellent video!
Great explanation! I now feel confident i can tackle this on my own and save $$$$! Thanks!
Glad to see this probably saved me a fortune
Great rundown, thanks!
These are great videos. I would say 99 percent of ski boats are running out of alignment and don’t even know it because they think the subtle vibration is normal.
Thanks, couldn't agree with you more, Most common response is "I didn't know it needed to be checked" Every boat/engine builder clearly recommends checking and adjusting as needed annually. Worst thing I ever heard was at this years International Boat Builder Exhibition and I noticed a ski boat engine on display that had a very if not impossible motor mount to get to, when I asked the rep about it he said "No one does alignments anymore, we don't worry about it".
Ron. Great videos. I had to completely replace my strut and shaft due to hitting ground. All is back together now with new coupler, stuffing box etc. of course I am off alignment so looking at adjusting. My motor is a pcm. My trunions look to be in decent shape but with some corrosion. A light attempt at adjusting reveals they are somewhat seized. Any tips other that penetration oil to help the along? Would applying some heat to the bore where the trunions go into the motor be a possible help. Any other tips?. All trunion nuts bolts on 4 corners loosened nicely. Thank you!
Hello,
Thank you for the video. My question is, will I need to replace the packing in the stuffing box after I pull it back to check the alignment in the shaft log or will the original packing be able to be reused?
properly adjusted stuffing boxes with good shaft alignment will last hundreds of hours between packing replacement, simply adjust as needed until you are out of adjustment, and always allow some dripping to assure proper cooling.
@@rontanis1024 thanks for the quick reply.
Looking for a prop shaft for a 1988 2001 ski naut any help
Harika
What is a flexible coupling for?
Inboard ski boats do not use flexible couplings, boats with a lot of room/distance between the shaft log and transmission may use a marine specific CV type joint.
@@rontanis1024 I have a 15metre cruiser with a DAF615 engine and a Paragon transmission. There is a 8 point rubber flexible coupling between the transmission and the propeller shaft but for some reason the output flange splines have worn very much. I can't understand why, even if the transmission and propeller shaft are not perfectly aligned the output shaft shouldn't wear so badly.