Anthony, Thank you sooooo very much for this series of videos. You've covered all of the steps that other sites were missing. Your pacing and attention to detail are excellent. I also appreciate that you are not hyping up every video, you are just presenting the information. This makes it much more enjoyable to learn from. Thanks again.
Awesome.....slowly going to watch all these videos. Thank you so much. But can you help show how to set up the 2 nema 17 steppers on the Y axis please? Thank you in advance.
help me pls! the stepper motor moves but when I set the speed above 800 or something it just vibrates how can I fix this pls I've checked its not the motors problem
Anthony,
Thank you sooooo very much for this series of videos. You've covered all of the steps that other sites were missing. Your pacing and attention to detail are excellent. I also appreciate that you are not hyping up every video, you are just presenting the information. This makes it much more enjoyable to learn from. Thanks again.
Awesome - finally, someone that can explain how do things in an understandable manner.
Awesome.....slowly going to watch all these videos. Thank you so much. But can you help show how to set up the 2 nema 17 steppers on the Y axis please? Thank you in advance.
Thankyou Anthony! One question; What about a jumper between ENable and Ground?
Great explanation.
dude thanks waiting for the next video
Thank you .
help me pls!
the stepper motor moves but when I set the speed above 800 or something
it just vibrates
how can I fix this pls
I've checked its not the motors problem
With all M1 M2 M3 jumpers installed in the stepper driver, it gives step divided by 32 which is too small. So remove M3 to make step divided by 16.
Thank you!
Hi Anthony,
many thanks for your explanation , it was so good, i have a question, where can i find it's code arduino?