*Unlocking the VTX is done by long pressing the configuration button for 10 seconds.* The VTX comes locked out of the box and you must follow this step in order to use an output power which is higher than 25mw.
The best VTX on market 5v , runs cool , 20 second press to get out of pit mode then you want all 3 lights steady on no Tramp betaflight needed I do not use I just set to highest power and leave .. crystal clear video long range I lose RF before video just freestyling with the X-rsx .. I have used these VTX's everyday and have not had one fail yet
Hi Gal I think I just seen my next VTX, I have been using a 600mw for a couple of quads, and I think it's time to try something new. Thanks again for the video and information.
I was going crazy when he was low batt 3km away.... and then he started doing tricks hahaha.... can't believe he made it back.... looking forward to test my 4s LiON
Nice video, I was doubting should I buy it, but now, no more doubt, adding to cart :) And that battery warning got me freaked out, especially at the long distance.
Thanks Gal! I was hoping you'd review this VTX! Impressive power output. Do you think the rolling horizontal lines are a result of the VTX or some other reason?
HI i have a tight 3inch slim toothpick build where there isn't much space, I searched everywhere online and didn't found any data about the thickness of the vtx with the heatsink on it. Could you measure it ? Thanks
Hey man, thanks for sharing that footage! Can you tell what camera were you using? It seems to me like that's Foxeer Razer Mini, but I want to be sure.
Hello. May I ask you how you mount this vtx in frame? Normaly on 20x20 mounting holes there are m2 holes for screws. On vtx all holes are m3. Did you use adapters or something different? Regards!
@@KremerFPV in the description are 3 different ones, can you tell me please which specific ones you had on the VTX as well which you had on your receiving end? The description is not really descriptive as to where the antennas are used. But great video!
Very interesting VTX. Do you think it would give a Rush Tank a run for its' money? (output seems stronger, but in terms of signal and build quality...)
I have this I am trying to put on a betafpv Elrs aio f4, i soldered it in and I’ve gotten video and betaflight says the vtx is ready, however I can’t get my osd to display. I am currently connected irc to t2pad video to cam pad 5v to 5v ground to ground. My irc wire is the only thing in uart 2. It’s been a struggle for me so if anyone has some knowledge on this it would be a blessing!
Yeah the real problem was the betafpv board every flight controller I’ve had from them was junk, the speedy bee tx800 works well for me now, I have it on a 2s quad and it really gets out there
![☀ Новинка для "динозавров". Аналог жив! [SpeedyBee Goggles Receiver]](http://i.ytimg.com/vi/d2ldsneCCKg/mqdefault.jpg)
*Unlocking the VTX is done by long pressing the configuration button for 10 seconds.*
The VTX comes locked out of the box and you must follow this step in order to use an output power which is higher than 25mw.
you have to do this every time you plug a battery ?
Nope. Just once.
@@KremerFPV thx Gal !
@@mode2fpv just FYI: if you do the 10second press after unlocking it will cycle between locked and unlocked states...
Can you change the mW while flying?
Quite a flight, especially the return. Nicely done, Gal
The best VTX on market 5v , runs cool , 20 second press to get out of pit mode then you want all 3 lights steady on no Tramp betaflight needed I do not use I just set to highest power and leave .. crystal clear video long range I lose RF before video just freestyling with the X-rsx .. I have used these VTX's everyday and have not had one fail yet
Awesome flying and review, Gal! 😃
That seems like a great VTX!!!
Stay safe there with your family! 🖖😊
You were really taunting that low battery! Just purchased tx800 for wing, im very impressed with it's signal strength.
I was using a LION battery ;-)
Hi Gal I think I just seen my next VTX, I have been using a 600mw for a couple of quads, and I think it's time to try something new. Thanks again for the video and information.
Anyone else think he wasn't going to make it back? 😂😂
I was going crazy when he was low batt 3km away.... and then he started doing tricks hahaha.... can't believe he made it back.... looking forward to test my 4s LiON
Nice video, I was doubting should I buy it, but now, no more doubt, adding to cart :) And that battery warning got me freaked out, especially at the long distance.
I hope you will enjoy it! I’ve used a LION battery, so there was no issue :-)
Seems a very good quality vtx
started to freak out when you were 4km out and under 3.5v per cell, but then realized you were probably running a LiIon lol
With low battery also u will do amazing things
Loved it!!! Great flying!!
✌️😃✌️
Impressive heat sink
Nice range. TX800 seems to do the job quite well. What antennas and what receiver are you using?
Top!
the goggles have to have a video receiver module attached to them?
What happens if I don't press the button for 10 seconds, but switch to the maximum power betafly option?
If it’s not unlocked the maximum output power will be 25mW.
@@KremerFPV thanks 🙏
That's f*ing cool Gal 👍
Thanks!
Thanks Gal! I was hoping you'd review this VTX! Impressive power output. Do you think the rolling horizontal lines are a result of the VTX or some other reason?
Possibly the dvr? I duno
Hi Gal, I am a bit confused. I have beta flight f4 FC. Should I get the power of the vtx from FC or ESC stack or do I need a separate 5v bec ? Regards
Hi, yes - you will need to power this VTX from a 5v BEC.
is it good? lets say compared to TX526 -600mw
HI i have a tight 3inch slim toothpick build where there isn't much space, I searched everywhere online and didn't found any data about the thickness of the vtx with the heatsink on it. Could you measure it ?
Thanks
Hi, it's in the video - 5.5mm.
Thanks Gal for review and flight demo. Just curious, what receiver are you using?
He’s using crossfire
You have some How to install Crawler scx24? Include FPV Camera RunCam Phoenix 2 SE?
Очень информативное видео. Лайк. Это liion батерея?
Thank you. Yes it is.
Top 🔝👌👍
Thanks!
I’m torn between this one or the zeus. Ordering tonight. The speedy bee looks great though and solid signal. 🤷🏽♂️
Both are good options. Enjoy your new VTX :-)
Hey man, thanks for sharing that footage! Can you tell what camera were you using? It seems to me like that's Foxeer Razer Mini, but I want to be sure.
Thanks for watching. I am pretty sure that it's the Caddx Ratel.
@@KremerFPV Thanks a lot! After watching your footage now I'm convinced to buy ratel nano 2 for my first 5in 😁
@@chekancov3 Enjoy it!
niceeeee
Thanks.
Mannn if you flew through that storage shed from over 300 m away that would have been epic. Still amazing vtx.
He did fly through a shed at like 350m away
@@jhughes2286 was talking the deep shed at the end was too much breakup still very impressive
It was a very hot day and I didn't feel like crashing it 😅
@@KremerFPV that would have been a terrible walk of shame
Hello. May I ask you how you mount this vtx in frame? Normaly on 20x20 mounting holes there are m2 holes for screws. On vtx all holes are m3. Did you use adapters or something different? Regards!
Hi, the VTX comes with m3 to m2 rubber grommets.
Did you power the camers from the 5v pad on the vtx or did you power the cam from either the fc vbat or the fc 5v?
I used the 5V pad of the FC.
@@KremerFPV Thank you 👍👍👍
You using a Lithium ION battery?
where. is the link to vtx table ?
Just added it to the video description.
What antenna did you use here ? And what mask / antenna as receiver ?
Please check the video description.
Amazing range you get there. Which Antennas u are using?
Thanks. Check the description of the video :-)
@@KremerFPV in the description are 3 different ones, can you tell me please which specific ones you had on the VTX as well which you had on your receiving end? The description is not really descriptive as to where the antennas are used. But great video!
Very interesting VTX. Do you think it would give a Rush Tank a run for its' money? (output seems stronger, but in terms of signal and build quality...)
Both VTXs are pretty good :-)
Where are the results of the competition for the polar camera?)
I was just wondering about this.
hes milking the fully watched views I guess
VTX Table you provided doesn't work FYI
Weird. Did you set the correct VTX smart control protocol?
What is better TX800 VS RUSH TANK ULTIMATE MINI?
Both are pretty good as far as I can remember.
@@KremerFPV thank
Hi Gal , i´ve change half of my rigs over digital but your vid remebers saying" Analog is not Dead" txt .
Yes it's still not dead 🤘
Great one, can you recommend me a good atenuator for the rc meter? Thanks
Thanks, sorry for the late response. I'm using a 10db attenuator that I got from a friend.
Não consego ir a 50 mentro com meu, onde errei?
Provavelmente nas antenas
I have this I am trying to put on a betafpv Elrs aio f4, i soldered it in and I’ve gotten video and betaflight says the vtx is ready, however I can’t get my osd to display. I am currently connected irc to t2pad video to cam pad 5v to 5v ground to ground. My irc wire is the only thing in uart 2. It’s been a struggle for me so if anyone has some knowledge on this it would be a blessing!
I am some problem
Yeah the real problem was the betafpv board every flight controller I’ve had from them was junk, the speedy bee tx800 works well for me now, I have it on a 2s quad and it really gets out there
Will it only take 5v ?
Yes
is the VTX table correct power showing label 800 but value only 600? manual shows band E where table there is no band E?
It should be correct.
@@KremerFPV there no E band or L band on the vtx table but shows available on website
How to use 800mw power output
VTX table is the easiest option. As far as I can remember it's not locked.
Hey dude how to unlock pleaseee😢
Unlocking the VTX is done by long pressing the configuration button for 10 seconds.
Everyone gets so far. All my drones including dji ones get a lil over 1.5miles and start to lose signal.
I was thinking the same thing watching this
Antenna gogle what.
It's listed in the video description.
U will be father of fpvs
Wow okay click buy!
:-)
These are absolute garbage. Very limited range and it melted down about a week into use. Fried itself. There are no tramp vtxs worth a damn
Maybe you have a faulty unit or the antenna was not connected properly.