How to make Solar Mobile Phone Charger
HTML-код
- Опубликовано: 24 авг 2021
- The circuit diagram of solar mobile charger consists of solar panel with control unit, fixed
voltage regulators.
The solar panel of 6V, 2W is used, the output of which varies based on the intensity of
incident light. This output is regulated through a control unit and is stored in a capacitor. This
capacitor produces an output of 5V which can be used directly to charge the load. A 5V fixed
output can be obtained by regulating the voltage from capacitor using an L7805 voltage
regulator and can be used to charge a 5V load. The battery can be regulated further to obtain
a 5V fixed output, using 7805 and charge a 5V load.
Components Required :-
1. IC 7805 x 1
2. Capacitor 1000uF x 2
3. Diode IN4007 x 1
4. Resistor 1K x 1
5. LED x 1
6. USB Female Connector x 1
7. Solar Panel 6V 2W x 1
8. USB Cable x 1
Thank You for Watching
#solarmobilecharger #phonecharger #batterycharge #solarcharger
easy to understand 👍👍
Awesome
👍👍
do u need an ac current to charge mobile? as I hv heard it will ruin the mobile if it is not charged properly
If you add a regulator to the circuit then it would be fine.
Tnx...
Welcome
Good
Thanks
How much voltage can we give it as input ?
Does it like fast charging?
So nice
Thanks
We can make directly by only adding transistor
Cuánto es el valor del resistor?
Corrier ayyt ee sathanam. Ayyach thero 🙃
Saat Sri akaal
Satshreeakal ji🙏
Next video a GaN charger!
5000mh ki battery charg kr paye ga ye
i need 2A bro
This is working ?
how to make a cellphone charger fast charging...
It's fast charging?
You use 6V 10W solar panel for fast charging.
The transitor 7805 has very low ampere .. less than 100 mili ampere so if you decide to use this circuit for charging 5000 mili amper cell phone battery you need 2 days to fully charge it !!
So 7805 is not suitable for this project
Jitne bhi video hai sahi se kaam nai krte ye project
2w cannot charge a smart phone
Yes, bro... But you can use 6V 10W solar panel and increase the current upto 1A to 1.5A
Thank you for Comment.
Output from circuit 5V 0.1A
But Mobile current requirement 5V 1 or 2 amp...
Yes, bro... But you can use 6V 10W solar panel and increase the current upto 1A to 1.5A
Thank you for Comment.
@@anuragprojects But I m already tired alot...load standby is failure...it showing only voltage on OFF load
You have used both capacitors 1000uF. Still Voltage is not stable.
Then you remove the diode from the circuit. Then try using it.
Still negative...!!!