Great video with lots of practical advice. My only comment is that when milling the large radius on the dividing head, if there is a center relief on the end mill then the resulting surface is curved and is a very small segment of a sphere. The end mill acts as a fly cutter and does not cut flat. Good project.
Yes, You're quite right. The resulting geometry depends also a lot of the orientation of the endmill. If the endmill is not center enough, so that the circle of the endmill end does not cover the top line across the workpiece, the resulting form may become strange. It may be pleasing but strange 😁
Great video with lots of practical advice. My only comment is that when milling the large radius on the dividing head, if there is a center relief on the end mill then the resulting surface is curved and is a very small segment of a sphere. The end mill acts as a fly cutter and does not cut flat. Good project.
Yes, You're quite right. The resulting geometry depends also a lot of the orientation of the endmill. If the endmill is not center enough, so that the circle of the endmill end does not cover the top line across the workpiece, the resulting form may become strange. It may be pleasing but strange 😁
Your videos are great. You explain everything so that even a cow will understand.😆
very good job finno