FS-i6 & FS-iA6B binding, FS-CVT01 voltage sensor installation

FS-i6 & FS-iA6B binding, FS-CVT01 voltage sensor installation
- Transmitter : FS-i6
- Receiver : FS-iA6B
- Voltage sensor : FS-CVT01 from banggood bit.ly/3b5yKZH

[@josephbonney7255]

Thanks so much! This was very helpful. I've had the TGY i6 transmitter for over a year, and I finally got a telemetry receiver, but I wasn't sure how to use it. This really cleared it up.
Can you install two sensors? I'm not sure if I can install an altitude sensor in the servo/s.bus port.

[@PeterAbt]

Thanks for the Video!
Do you know if there is any way to turn of the Voltage Alarm?
Because when I have my motor on - full throttle the voltage drops down quiet drastically - so low - that the alarm goes off.
But I want to keep the high- low-voltage settings so that there I can keep the beautiful battery animation at the top right corner of the display.

[@owlbruno]

Super,, Danke für das tolle Video,, 👍🍺

[@jayrermars8493]

Hi, my receiver came with red rubber on the ends of the antennas, just as yours have black rubbers in the vid. Should these be removed or not? Many thanks.

[@RCstagram]

Antenna cable noise filter inside the tube. Don’t remove it.

[@aqkhana2002]

Can you help me in my radio i can see err 1:0% what that mean ?

[@stewm400driver]

Can this voltage sensor be used with other brands of RX?

[@RCstagram]

Mark Stewart I don’t think so.

[@arnoudwalrecht8479]

Question: can I operate two sensors (volt and temp) at the same time? Thanks a lot

[@feltav5719]

Same question... Any answer?

[@arnoudwalrecht8479]

@@feltav5719 yes, just connect them through

[@feltav5719]

@@arnoudwalrecht8479 through what?

[@arnoudwalrecht8479]

@@feltav5719 each other haha

[@feltav5719]

@@arnoudwalrecht8479 gotcha lol

[@chrisgiles5389]

how many models memorys does this have?

[@RCstagram]

Up to 20 models.