Harley Road King LED Turn Signal Conversion

Поделиться
HTML-код
  • Опубликовано: 7 янв 2025

Комментарии •

  • @MinnowMoto
    @MinnowMoto 3 года назад +2

    They turned out great. That plug in resistor really made the process much easier that I thought.

  • @babybugspaw7085
    @babybugspaw7085 2 года назад +1

    Great Video my fellow Road King Owner,
    Keep doing videos, great info!

    • @kalways_kustoms
      @kalways_kustoms  2 года назад

      Thanks for the kind words, and thanks for watching!

  • @OSOFLHP
    @OSOFLHP 10 месяцев назад +1

    I think I'd rather put that heat on the rear fender than the battery.
    But your video answers my question about the load balance

  • @jeffquinones4007
    @jeffquinones4007 11 месяцев назад +1

    Will fit 04 softail? The ebay ones are much bigger but same numbers 3 1/4

    • @kalways_kustoms
      @kalways_kustoms  11 месяцев назад

      Not sure on that....the softtail directionals are usually a bullet style with a smaller diameter. I'm pretty sure they wouldn't fit. But I'm sure the correct ones are out there. Thanks for watching!

  • @tlagumina
    @tlagumina Год назад +1

    So. I did the same. Mine don’t flash at all. Brake light works but the turn signals? Don’t light up as running lights and turn signals only operate manually. Meaning. You push the turn signal button, the light comes on, push it again, the light goes off(no blinking)… what would cause that?

    • @kalways_kustoms
      @kalways_kustoms  Год назад

      Off the top of my head, I'm not quite sure. Possibly a bad resistor? Or a ground not doing its job? You may need to do some troubleshooting. Wish I could be of more help. Thanks for watching!

  • @mjmjross
    @mjmjross Год назад +1

    Just wondering if it's still working properly? Mine blink normal UNTIL I touch the brake, then I get 2 more regular blinksbefore it start hyper blinkking again. I've tried the resyncing procedures but so far non of them have worked on a 2004 Electra Glide.

    • @kalways_kustoms
      @kalways_kustoms  Год назад

      Everything is still working properly. Thanks for watching!

  • @RobertBresher
    @RobertBresher Год назад +1

    Did you have to get a different resistor. For the front harness

    • @kalways_kustoms
      @kalways_kustoms  Год назад

      I did not. There are two resistors in the harness. One for the front and one for the back. Thanks for watching!

  • @mrantone916
    @mrantone916 3 года назад +2

    I found out you need to install these also on motorcycle to avoid overcharging from the rectifier, mosfet upgraded also, it will compensate and sent more energy to the battery and in turn fry your battery.

    • @kalways_kustoms
      @kalways_kustoms  3 года назад

      That makes perfect sense. Thanks for watching!

  • @OSOFLHP
    @OSOFLHP 3 года назад +1

    What happens if you try to run automotive 1157a LED bulbs their like 20. A pair then add the load part?

    • @kalways_kustoms
      @kalways_kustoms  3 года назад +1

      I think it would work the same way. I had a hard time finding decent ones in red. That was the reason I went with the kit. Thanks for watching!

  • @tw-tg7lc
    @tw-tg7lc 2 года назад +1

    Now that it's been some time since you installed them. Is it still working? I'm about to install, and I'm worried about the equalizer over heating.

    • @kalways_kustoms
      @kalways_kustoms  2 года назад +1

      Not one issue with them. No overheating at all. As long as they can hang freely or mount to some steel that will dissipate the heat, they are fine. Thanks for watching!

  • @oscie1989
    @oscie1989 10 месяцев назад +1

    I bought the same kit for my 2000 road king . But they wont blink any Thoughts?

    • @kalways_kustoms
      @kalways_kustoms  10 месяцев назад

      Off hand, no. Won't blink at all?

    • @oscie1989
      @oscie1989 10 месяцев назад

      @@kalways_kustoms at all . Im comfused

    • @kalways_kustoms
      @kalways_kustoms  10 месяцев назад

      @oscie1989 are you sure they are the correct bulb socket number (1156,1157), because if the socket is different and it doesn't make contact, that could do it.

  • @Jacblack69
    @Jacblack69 Год назад +1

    Hey how's it going,what year is your road king? Mines a 2011 and I been looking for a front fairing like what you have ,what brand is it

    • @kalways_kustoms
      @kalways_kustoms  Год назад

      My Road King is an 04....the fairing is from the USA Trailer Store on eBay. It's hit or miss on his stock. You just gotta keep checking. Thanks for watching!

    • @Jacblack69
      @Jacblack69 Год назад +1

      @@kalways_kustoms appreciate it i wish you could install mine,I. I'm on part #4 of your install wish I saw this before I asked a stupid question 😆 🤣 😂

    • @kalways_kustoms
      @kalways_kustoms  Год назад

      @@Jacblack69 It's all good. I appreciate the views.

  • @donpaul9576
    @donpaul9576 2 года назад +1

    I have the exact issue andI have been searching to see if this would fit a 2013 Ultra Limited and seems I cannot find any info on this. Do you have any idea if this would and if not, which one would without spending $80 for the "Badlands". Good video, thank you.

    • @kalways_kustoms
      @kalways_kustoms  2 года назад

      I don't see why it wouldn't work with your Ultra. I'd say it would be worth a try. This setup is still working great, and at a fraction of the price of the Badlands. Thanks for watching!

    • @donpaul9576
      @donpaul9576 2 года назад +1

      I got the resistor to stop the Hyperflashing and it also turned off the security warning light. They do get hot. So on my bike there was no place to stuff them. I had to secure them on top of my security module that is over my battery. I'll ride around and check it. Thank you.

  • @mikebronc2902
    @mikebronc2902 2 года назад +1

    What kind of fairing is that?

    • @kalways_kustoms
      @kalways_kustoms  2 года назад

      The fairing is from the USA Trailer Store on eBay. There is a playlist on the channel showing the full installation. Thanks for watching!

  • @ahutch40
    @ahutch40 Год назад +1

    What taillight is that you have?

    • @kalways_kustoms
      @kalways_kustoms  Год назад +1

      It's an eagle claw led taillight. I did a review video for it on the channel. Thanks for watching!

  • @russellmcdonald6033
    @russellmcdonald6033 3 года назад +2

    Looking at getting these lights for my 03 road king. How have they held up since you installed them? Still a good buy?

    • @kalways_kustoms
      @kalways_kustoms  3 года назад +1

      They have been great. No issues at all. Thanks for watching!

  • @rodneysitterson1702
    @rodneysitterson1702 4 месяца назад +1

    What brand of fairing?

    • @kalways_kustoms
      @kalways_kustoms  4 месяца назад

      It came from the USA trailer store on ebay. Thanks for watching!

  • @rileyjohnson5607
    @rileyjohnson5607 2 года назад +1

    Where did you get the front fairing?

    • @kalways_kustoms
      @kalways_kustoms  2 года назад

      I purchased the fairing on eBay. The name of the seller is USA Trailer Store. Best quality fairing for the money. Thanks for watching!

  • @1Rooster338
    @1Rooster338 3 года назад +1

    Did you have to use a separate flash resistor for the front?

    • @kalways_kustoms
      @kalways_kustoms  3 года назад

      No, the resistors covered the front and back. Thanks for watching!

  • @eperreault9107
    @eperreault9107 3 года назад +2

    Hey fellow granite stater!! Thanks for the vid and links. You planning on adding the rapid flash brake light module?

    • @kalways_kustoms
      @kalways_kustoms  3 года назад

      I hadn't planned on adding one, although they really are a great mod for increased visibility. Thanks for watching!

  • @GQ-Kingrider-st
    @GQ-Kingrider-st 2 года назад +1

    Does the rear stay on as running lights

    • @kalways_kustoms
      @kalways_kustoms  2 года назад

      There is a running light that stays on at all times. Thanks for watching!!!

  • @lotus14
    @lotus14 3 года назад +1

    Where did you get that license plate holder?? I have a ‘16 FLHP and removed the laptop/truck frame off the back, but it has the license plate holder on it. So I’m just using Velcro.. is that something you bought somewhere? Looks great

    • @kalways_kustoms
      @kalways_kustoms  3 года назад

      Honestly, it's just a cheap one off eBay. I think it was 9 dollars. It's just plastic. I was actually thinking about getting a better one soon. Thanks for watching!

  • @kennybarber4754
    @kennybarber4754 2 года назад +1

    Great video, where did you get your LED brake light on the back of your bike?

    • @kalways_kustoms
      @kalways_kustoms  2 года назад

      I purchased it through Amazon. It's been a great light. I actually did an install/review video of it on the channel. Thanks for watching!!

    • @kennybarber4754
      @kennybarber4754 2 года назад +1

      @@kalways_kustoms I actually found your video last night. Thanks for the content, it helps a lot.

    • @kalways_kustoms
      @kalways_kustoms  2 года назад

      Glad you found it helpful!

  • @thomasmcdaniel1095
    @thomasmcdaniel1095 3 года назад +1

    If the goal is increasing visibility why would you use a dark lense?

    • @kalways_kustoms
      @kalways_kustoms  3 года назад +2

      The led lights are so bright that the smoked lenses don't affect visibility at all, plus it gives it the look I was going for. Thanks for watching!

    • @thomasmcdaniel1095
      @thomasmcdaniel1095 3 года назад +1

      Love the look myself, and thank you for the links, made finding everything so much easier. New lights all around next weekend. Any other mod recommendations?

  • @TheVeroneeLife
    @TheVeroneeLife 3 года назад +1

    Nice video bud, about to do the same to mine!

  • @Squalls_
    @Squalls_ 3 года назад +1

    Great video! 👍

  • @Big88Country
    @Big88Country 2 года назад +1

    Check out Custom Dynamics lights, they are awesome and they will sell you a single plug in that doesn't get hot and they work great. Just made a comment on your bag filler stripes video about the bag lights as well from Custom Dynamics. I went with the smoke lenses as well.

    • @kalways_kustoms
      @kalways_kustoms  2 года назад

      I will definitely check them out. Thanks for watching!

  • @RealWhiteComedy-ev5gx
    @RealWhiteComedy-ev5gx 4 месяца назад +1

    I tell you what I'm not worried about the hyper Flash

    • @kalways_kustoms
      @kalways_kustoms  4 месяца назад +1

      I hear you. I'm just picky. Thanks for watching!

  • @jackgzhang135
    @jackgzhang135 2 года назад +1

    Hello, we are an amazon seller for Harley's 7 inch headlights. Would you like to make a video about our product? We can send you our product sample.

    • @kalways_kustoms
      @kalways_kustoms  2 года назад

      Sure.

    • @jackgzhang135
      @jackgzhang135 2 года назад +1

      @@kalways_kustoms Can you share your other contact, like instagram or facebook?

    • @kalways_kustoms
      @kalways_kustoms  2 года назад

      You can reach me at kalwayskustoms@outlook.com
      Thanks!

  • @TKO-NY
    @TKO-NY 3 года назад

    Love how the RK is lookin, but dude, you talk way too much.