How to use a Johnson Rotary Laser Level | Building Tips for DIY SEPTIC & Foundation leveling
HTML-код
- Опубликовано: 18 июн 2021
- In this quick video, we walk you through how we use the Johnson Self Leveling Rotary Laser Level. This tool has been essential for installing our septic lines, and preparing our slab foundation! There are many out there - but here is the brand we have.
www.homedepot.com/p/Johnson-S...
www.homedepot.com/p/Johnson-U...
Check out our merch! home-veneer.creator-spring.com
Don't forget that we have an instagram as well. homeveneer...
#homeswithpurpose #makehomematter #newhouse #buildbeautifulthings #tennesseecountryhome #mybuildingjourney #mybuildjourney2021 #housebeautiful #housewithaview #custombuilder #construction #ramsayTNhome #homebuildingprocess #homebuildingjourney #homebuilding101 #homebuilding #landdevelopment #buildingdiy #homediy #laserlevel Хобби
Best demonstration on youtube thus far
Thanks. Hope it helps.
@@DreamitBuildit I agree, I have watched 20 minute videos that explained less!
I just pulled mine out of the case after years of sitting unused and thought hmm, been awhile. I wonder if there's a refresher for these on RUclips? Thank you!
Glad it helped!
Thanks understood u more than anyone else
glad it was helpful!
Thank you, very helpful
Glad it was helpful!
dude your amazing I just discovered channel your videos are very very helpful.
Glad to hear it!
Thanks for getting out of bed for that. Well done! 😂😂
Nice job on the video
Thanks! Hope it helps.
Thanks, I have plans on building a retainer wall. At a thrift store today 6/15/22 and found one in the case complete and it works, $50.😍
Great deal!
thanks for the video
Hope it helped!
@@DreamitBuildit it sure did!
Thanks again :)
My receiver beeps at random even when I am nowhere near the correct height. Sometimes it gets so bad, it just beeps continuously at any height and I can't tell when I am in the beam or level. Kind of as if it gets interference even though I'm in the woods with nothing around. Has done it randomly since new. Any ideas?
Good question. Not sure on that. For us, if we reset the calibration it usually fixes that. Other than that I'd check the batteries or contact the manufacturer/ seller.
How do you use it to make sure posts are at the same height?
Same method as shown, I would just set it where the laser will hit the top of the post. I’d they’re already set, you can mark where the laser hits and cut the top off.
Jajaja all 3 of our followers
but what if you want to measure beneath the surface?
Not sure what the situation is, but that pole with the receiver can be adjusted quite a bit. You just have to be able to make visual contact with the laser.
I am digging a pool, so I need to dig down 44 1/2 inches. So i take my measure stick, and I find level for the top of my pool wall. Then, I move the laser reader up the pole 44 1/2 inches. So once I dig down 44 1/2 inches, it will register level again at my reference point, which will be at the top of my pool wall.
Do a garde video u will be surprised
What's a garde video?
Is it a good laser level?
$ 🎉🎉e🎉Eden 🎉e i🎉🎉e
I'm building a pool
Like ya said, that’s kinda how you use it. I was hoping you were going to tell us how to use it on a slope instead of what I figured out in 5 minutes on my own
Yep, we used it just a bit on a slope when we first started our septic field, but mostly for prepping this foundation.