extremely helpful video!, also one question i have a very tiny gap in between the adapter and the mag, like its not fully flush against the adapter but there is no signs of leaking do you think i should keep trying to make it flush or leave it as it is because i dont think it can go any further and i think if i keep trying i might break it
You will almost always get the tiniest of gaps due to allowance for tolerances. It will be fine as the seal is done on the oring above. My older gen2 was visible but newer gen3 isn't as bad.
![COLOMBIA vs. CHILE [4-0] | RESUMEN | ELIMINATORIAS SUDAMERICANAS | FECHA 10](http://i.ytimg.com/vi/TDjN4W3yy1k/mqdefault.jpg)
extremely helpful video!, also one question i have a very tiny gap in between the adapter and the mag, like its not fully flush against the adapter but there is no signs of leaking do you think i should keep trying to make it flush or leave it as it is because i dont think it can go any further and i think if i keep trying i might break it
You will almost always get the tiniest of gaps due to allowance for tolerances. It will be fine as the seal is done on the oring above. My older gen2 was visible but newer gen3 isn't as bad.