Great looking job! Especially when using those hard steel lines. I have done one this week but I used copper nickel line, so I was able to make the complete lines without needing joints. I don't know if they are available in Europe. You buy a 25' coil and feed it from the front and bend it as you go ( since it's very malleable).
Thanks for the feedback. Great works completeing this task too and your correct its easier to use the copper nickel line and also its definately easier doing the pipes in one part no joints. Thank you for taking the time to watch my video too 👍
@WhildeAutomotiveLTD no, thank you for taking the time to post this valuable information. Your video helped me figure out what I was up against before tackling it. Btw, I did have to lower the fuel tank a little bit to get to those 2 clamps around it.
Presumably using those pipe couplings, you have a single flare on one pipe and a double flare on the other pipe ? I would use a three part coupling with DIN single flares on both pipes. Never had much confidence in double flaring an old steel pipe.
Question Sir… Need to replace the foot brake cable line from rear to front is it a straight line from rear to foot brake? any info would help.. ML350 2007 job on the weekend.
Great looking job! Especially when using those hard steel lines. I have done one this week but I used copper nickel line, so I was able to make the complete lines without needing joints. I don't know if they are available in Europe. You buy a 25' coil and feed it from the front and bend it as you go ( since it's very malleable).
Thanks for the feedback. Great works completeing this task too and your correct its easier to use the copper nickel line and also its definately easier doing the pipes in one part no joints. Thank you for taking the time to watch my video too 👍
@WhildeAutomotiveLTD no, thank you for taking the time to post this valuable information. Your video helped me figure out what I was up against before tackling it. Btw, I did have to lower the fuel tank a little bit to get to those 2 clamps around it.
Nice job 👍👍👍🏴
Thank you 😀
Sorry for the slow response. Thank you for your feedback. I appreciate you watching my video. 👍
Presumably using those pipe couplings, you have a single flare on one pipe and a double flare on the other pipe ? I would use a three part coupling with DIN single flares on both pipes. Never had much confidence in double flaring an old steel pipe.
Question Sir… Need to replace the foot brake cable line from rear to front is it a straight line from rear to foot brake? any info would help.. ML350 2007 job on the weekend.