MERCEDES BLIND SPOT INOPERATIVE FIX

Поделиться
HTML-код
  • Опубликовано: 15 окт 2024
  • MERCEDES BLIND SPOT INOPERATIVE PROBLEM/FIX w212 E350 2012,in my case was bad radar sensor, i have to replace it,...most of this problemes are from bad conection cable,or blow sensor...good luck ! like and share thx

Комментарии • 46

  • @user-pu3cf9pd2m
    @user-pu3cf9pd2m 3 года назад +4

    Was driving today and randomly it the car would brake/tighten my seatbelt many times throughout the drive and in the dash it would say there is a car in my blindspot. Did not get blind spot inoperative in the dash, and the lane change beeping was working fine. Got home, rinsed the exterior of the vehicle, and was still getting the problem. Located the sensor on the right side of the rear bumper near the muffler, in my case it was the right side that was the bad sensor. It was extremely dirty. Got a wet paper towel and cleaned it and then got the hose and sprayed the sensor (did this knowing it COULD cause damage to the sensor, I pretty much thought that the sensor needed replacing anyway). Took it for a drive, and the issue resolved. I know this won't work for everyone, but my sensor was very dirty. I took a look at the left one, and it wasn't as dirty so I left it alone.

  • @tonya6191
    @tonya6191 3 года назад +3

    Would you happen to know how to access this these sensors on a 2012 GL450?

  • @realworld822
    @realworld822 Год назад +1

    I have the same problem after scanning the car it was saying right sensor it's working, I switched right to left sensor and scanned the car again thinking it would be the left one but no still the right side was the problem
    Any help would be appreciated 🙏

  • @Truthfullyspoken66
    @Truthfullyspoken66 11 месяцев назад +3

    What’s the part number?

  • @unclesam1707
    @unclesam1707 3 года назад

    Mine on the ml350 w166 looked good no damage to it but wondering where is the cable going to from the sensors it coud be them and l wish l have a proper way to test them with multimeter or battery!

  • @S-u-p-a
    @S-u-p-a 2 года назад

    Question the sensor being bad did it cause any issues with gearbox shifting?

  • @Em-ud7ic
    @Em-ud7ic 4 года назад

    Hello DJ-My sensors are working however there suddenly is no audible in my 2015 GLK 250-any experience with this? TY

    • @MrDjsimba
      @MrDjsimba  4 года назад +1

      Hmmm..sorry i don't know about...if I will find something I will let you know..b

    • @Em-ud7ic
      @Em-ud7ic 4 года назад

      @@MrDjsimba TY

  • @edcogan6084
    @edcogan6084 3 года назад +4

    How does the sensor come out of the holder? It is blocked on the front and the back and then there is a strap across the top that doesn't move.

    • @MrDjsimba
      @MrDjsimba  Год назад

      Yes,take the 2 strap and that's all,this how was for mercedes 2012

  • @omolina91
    @omolina91 4 года назад

    Hi, any tips on how to dig out a pin that got stock to the connector ? I got the piece now I've got to replace the wire harness...for one little pin...:-(....thanks for your video, best!

  • @nabileo2
    @nabileo2 3 года назад

    Hi there. Very informative. Do you have to reset or do programing after installation ? Thank you

    • @MrDjsimba
      @MrDjsimba  3 года назад

      Yes, I just replace with used part, and is not working, is the same serial number. I will call thr dealer to ask about program, I will let you know,

    • @nabileo2
      @nabileo2 3 года назад

      Thank you

    • @nabileo2
      @nabileo2 3 года назад

      @@MrDjsimba Final question. Is there a right and left ? or its the same part for either side. Thank you

    • @MrDjsimba
      @MrDjsimba  3 года назад +1

      @@nabileo2 Yes the are 2 of them, 1 each side , left and right, I spoke with one dealer today ,they said need to be calibrated after installation but not guaranteed will work because I installed use one...and will cost 190$ here in NAPERVILLE USA...I will try to check with another dealer ...this mechanic wasn't sure ,no clue...

    • @nabileo2
      @nabileo2 3 года назад

      @@MrDjsimba Thank you and all the best.

  • @660ccRaptor
    @660ccRaptor 3 года назад +1

    Is it the same with s550 2009?

  • @almighty9662
    @almighty9662 4 года назад

    Theres 2 sensors on both sides which one should i take out to try to clean and try it back

    • @MrDjsimba
      @MrDjsimba  4 года назад

      Yes,of course you have to check both sides, in my case was passenger side but could be driver side ,you have to check both, if they looking good check the cable,both sensor, if the cable is broken you have the same erro,message,

  • @armingluhic
    @armingluhic 2 года назад

    Jel se moze rasklopiti elektronika ili je zalivena voskom

  • @kennyt9207
    @kennyt9207 3 года назад

    Hi can you replace the sensor without removing the bumper?

    •  3 года назад

      Yes you can, but you must have skilled hands :)

    • @EpicStays
      @EpicStays 3 года назад

      @ I must know how. Can you describe?

    • @drfofo
      @drfofo 2 года назад

      Do I need to replace the sensor or just connect the clips?

  • @michelnadon6243
    @michelnadon6243 Год назад

    does the new sensor need coding

  • @moozounfamily6067
    @moozounfamily6067 3 года назад

    Can you repair this instead of replacing it. Can I just open it up and clean it up?

    • @MrDjsimba
      @MrDjsimba  3 года назад

      In my case i try it,no luck,dosent work...but you can try

    • @ElRevelator
      @ElRevelator 3 года назад +1

      @@MrDjsimba Does it need to be reprogrammed when you swap it out?

  • @PMW442
    @PMW442 2 года назад

    I need this part but I can't find the part # for a 2013 Mercedes ML63 AMG. Anybody know?

  • @denisveste3890
    @denisveste3890 2 года назад

    Plug and play?

  • @mercvqcali2714
    @mercvqcali2714 2 года назад

    Mine isn't working got it looked at and they said I need a whole new steering wheel it's gonna be 2400$

  • @Phuong_Nguyen_
    @Phuong_Nguyen_ 2 года назад

    How many does a car have?

  • @MLumar
    @MLumar 4 года назад +1

    Please share a link for the replacement.. thanks

    • @MrDjsimba
      @MrDjsimba  3 года назад +1

      Give me the part number, located on your old sensor...try to search it on ebay,,,sensors are not the same..depends what year is the car and series....

  • @altanyetkin
    @altanyetkin 3 года назад

    Thanks 👏👏🙏🙏🙏🙏

  • @tss91994
    @tss91994 4 года назад

    Terrible. Unplugging a sensor and swapping it is the easy part of the job. Figuring the problem is the hard part.

  • @kevinparsi9572
    @kevinparsi9572 4 года назад +1

    Ugly music not match with this good RUclips clip