Dealing with low idle at the moment it was around 400 it actually stalled on me once when I was at a red light yesterday but when idles low it starts shaking a little bit. Going to give this a try whenever I get home today.
Dealing with this same issue with a 2001 CRV. I was hopeful that doing what you did was going to fix it, but after cleaning the throttle body and replacing the IACV with an OEM Denso and adding a new MAP sensor, the low idle still persists. Fuel trims rule out a vacuum leak. Going to try cleaning the throttle body this weekend and hopefully find some blockage that I'd previously missed. I'm certain what you posted is helpful for those merely suffering from a dirty throttle or IACV.
Seriously do this guys...Buy or use a micro sonic cleaner (with heater option) and do a proper cleaning, all it takes is grease cutting dish soap and tap water. It will work for many other parts! Should have seen how my hood latch turned out too! The high heat of the water will dry fast and it will be thoroughly cleaned right!
Trying to remove clamp that holds pipe on throttle body. The nut for the clamp is hidden at the bottom facing back of engine. What size nut is it? I'm blindly trying to get a socket on it without much luck.
Is your Prelude still idling normal after all this time? My Prelude is starting to have a low idle issue just wanted to know that it's solve the problem permanently? Any guidance will be much appreciated thank you.
Disconnect both battery terminals put headlights on to drain any current, replace the terminals of the battery + first. Then start the car with all accessories off, and if manual do not depress the clutch, let the car idle for five minutes, and then drive it for about 20-25 minutes, then the ECU will memorise how you drive.
Is it okay to have coolant spill, might fuck around and do this . Hopefully my car does not explode since i am not mechanically inclined lol. Have a 00 lude with p0505 and p0420
Syphon the coolent out (from the rad cap) until its below the line level you are trying to undo....and then just put it back in when done, simple as that.
Dealing with low idle at the moment it was around 400 it actually stalled on me once when I was at a red light yesterday but when idles low it starts shaking a little bit. Going to give this a try whenever I get home today.
Dealing with this same issue with a 2001 CRV. I was hopeful that doing what you did was going to fix it, but after cleaning the throttle body and replacing the IACV with an OEM Denso and adding a new MAP sensor, the low idle still persists. Fuel trims rule out a vacuum leak. Going to try cleaning the throttle body this weekend and hopefully find some blockage that I'd previously missed. I'm certain what you posted is helpful for those merely suffering from a dirty throttle or IACV.
Seriously do this guys...Buy or use a micro sonic cleaner (with heater option) and do a proper cleaning, all it takes is grease cutting dish soap and tap water. It will work for many other parts! Should have seen how my hood latch turned out too! The high heat of the water will dry fast and it will be thoroughly cleaned right!
Thank you for the video bro really good quality and in depth detail. Thanks again bro your a 🌟
This just worked great! Thank you so much
That ain't dirt fellas that's carbon build up
Do you have to bleed the system after cleaning? Allot of other videos I’ve watched they didn’t bleed the system
Where’d you get that mugen intake?
Trying to remove clamp that holds pipe on throttle body. The nut for the clamp is hidden at the bottom facing back of engine.
What size nut is it?
I'm blindly trying to get a socket on it without much luck.
Is your Prelude still idling normal after all this time? My Prelude is starting to have a low idle issue just wanted to know that it's solve the problem permanently? Any guidance will be much appreciated thank you.
Yes for my car it did work permanently, maybe your cars running too rich or lean
Disconnect both battery terminals put headlights on to drain any current, replace the terminals of the battery + first. Then start the car with all accessories off, and if manual do not depress the clutch, let the car idle for five minutes, and then drive it for about 20-25 minutes, then the ECU will memorise how you drive.
All I did was loosen and tighten back up the throttle wires it kept going up and down at first
man this was a good ass video
Good video bro
Hey bro I pushed that mesh in to hard and it’s not popping out it’s in dented. And my cars dying even more now any way to pull the mesh out
Hey mate, Where'd you get your spoiler? I've got a black 1999 Vtir
yo i did this today and now my gas pedal is loose what did i do wrong ?
Hey what spoiler is that cool prelude btw
Why did my coolant come out of the hose and not the run off valve
How did you get your bar off? Looks like it takes a allen wrench?
Yo bro, where did you get your spoiler? I been looking for one like yours and can't find one
Came stock in some SiR & Vtir models in NZ
Where did you get the part from
What is that breather filter connected to
The valve cover?
What spoiler do you have
Is it okay to have coolant spill, might fuck around and do this . Hopefully my car does not explode since i am not mechanically inclined lol. Have a 00 lude with p0505 and p0420
yeah well you could put a rag under it but it shouldn't do anything bad besides leave a little mess
Syphon the coolent out (from the rad cap) until its below the line level you are trying to undo....and then just put it back in when done, simple as that.
Definitely didn't need to crack your bleeder screw for that tiny bit of coolant loss.
i realize it's pretty off topic but does anyone know a good site to stream newly released series online ?
@Wayne Kaleb i dunno lately I have been using flixportal. just google after it:) -santiago
@Santiago Cassius Thank you, I signed up and it seems like they got a lot of movies there =) I really appreciate it!!
@Wayne Kaleb Happy to help xD
After completing this process, my car now idles too high, around 1200 rpm. I bled the coolant system as well. What could be causing this?
did you plug in the idle air control valve correctly?
Your car is overheating bro
I'm glad someone else noticed it was making me cringe
Very risky cleaning that with a paper
Dude, paper is carbon, don't panic.