Don't forget to clean the rust out of the threads. Then you take it apart again to put the elbow attachment on the end. Remember to use extra sealant because the threads have been cut backwards and you can't tighten it all the way. The quality of these directions are representative of the quality of the product.
Ha At least you got instructions mine didn't even come with any. Short of that, mounting holes for the compressor were 3/4" off from where they should of been.Total scrap junk.
Go to this site to see a similar tank hooked up to a compressor. Hope this helps.upscalehobbies.com/airbrush-accessories/2210-testors-aztek-ac500-airbrush-compressor-w-tank.html. P.S. I do not work for this company . I just did this on my own because I got pissed off watching this video.
Lousy video. But go to this site:upscalehobbies.com/airbrush-accessories/2210-testors-aztek-ac500-airbrush-compressor-w-tank.html. There you will see a picture of the tank hooked up to a compressor. Hope this helps.
Don't forget to clean the rust out of the threads. Then you take it apart again to put the elbow attachment on the end. Remember to use extra sealant because the threads have been cut backwards and you can't tighten it all the way.
The quality of these directions are representative of the quality of the product.
Amen Bruddah just got mine today. Terrible quality Chinese Shite
Ha At least you got instructions mine didn't even come with any. Short of that, mounting holes for the compressor were 3/4" off from where they should of been.Total scrap junk.
Do you have a complete video of the pressure sensorand regulator install .
avez vous trouvé ? je suis preneur aussi
Go to this site to see a similar tank hooked up to a compressor. Hope this helps.upscalehobbies.com/airbrush-accessories/2210-testors-aztek-ac500-airbrush-compressor-w-tank.html.
P.S. I do not work for this company . I just did this on my own because I got pissed off watching this video.
@@lordofdunvegan6924 Does not help at all. I can fin picture anywhere, I need the process of how to attach it.
Hi, will my Fengda AS18 compressor fit this tank?
Dear friend,
As long as the dimensions of 4 connection holes distances match to your air compressor,it can work.
Lousy video. But go to this site:upscalehobbies.com/airbrush-accessories/2210-testors-aztek-ac500-airbrush-compressor-w-tank.html. There you will see a picture of the tank hooked up to a compressor. Hope this helps.
It isnt even the same tank design.. how about being helpful and not an idiot. The link you provided was lousy and useless.