Move the upper thumb mount higher. Bring dipper in as far as it goes and weld tabs higher. Keep in mind to keep a bit of angle in tooth claw if it is straight it can go both directions randomly every time you use it.
I would think on a machine of that size you would just swap the bucket pins and not bother with a quick connect. It would probably take about the same amount of time and not loose force and add weight.
It takes about 5-7 min to change pins without quick-connect, which is fine. but the pins are really greasy and I’ve extended the thumb to match with the quick connect. I also like that the boom has more reach.
Move the upper thumb mount higher. Bring dipper in as far as it goes and weld tabs higher. Keep in mind to keep a bit of angle in tooth claw if it is straight it can go both directions randomly every time you use it.
I would think on a machine of that size you would just swap the bucket pins and not bother with a quick connect. It would probably take about the same amount of time and not loose force and add weight.
It takes about 5-7 min to change pins without quick-connect, which is fine. but the pins are really greasy and I’ve extended the thumb to match with the quick connect. I also like that the boom has more reach.
Good video your like me that’s your side kick can’t have it broke
We fix it:)
That engine sounding like some bad knocking going on
@@dakotak8437 it’s one cylinder
@@torkelsenhus I got ya lol
You should really really really get a plasma cutter :D
Yes, I should. They are very expensive I believe?
@@torkelsenhus you are located where? Some cheap ones that can cut about 12mm are in Europe about 200€. But its the max cut. Clean cut is about 6-8mm.
@@inseiin I’m in Europe. Okay, that’s not bad. I’ll have to look into that.