little mistake @ 5:02 you need to "massage" the bubbles out before you remove the 2nd layer, otherwise you'll end up scratching your screen protector with the card (trust me, it can happen, even on "scratch proof" protectors). other than that it's a good tut, thanks!
Thanks for the great video! However my installation went bad in every possible way. Even though doing everything meticulously and positioning the tray straight on top of the Deck, my protector went off to the left almost 1 mm. I ended up with a small bubble in the center of the screen which didn't move at all even though I massaged it couple of minutes. Also, it's hard to find a dust-free environment, so there's always some dust specks on top the screen which are trapped between. I tried to reposition and clear out the bubble by prying it from the corner, but it broke the glass (just the corner part). Best part of the installation was the fact that it cost only 20 € to try it and throw it to the bin. Don't get me wrong, the product was ok, especially with all the accessories included.
Would all the cleaning steps be necessary if the Steam Deck has only just arrived, fresh from the factory? I've only opened the case in the past few minutes just to see it, but haven't taken it out, and re-sealed it.
You'd be surprised at what can get on the screen immediately after cleaning it (stupid fuzz/lint). So I would still recommend cleaning it and using the sticker afterwards
@@SteamDeckExplained I ended up following all the cleaning instructions because of that reason. I haven't been able to find anything stuck under the screen, so it appears to have been a success!
Really wish someone would show the methods of removing a screen protector if ever needed. Everyone is just how to install. Plus idk how to tell if mine has any installed
little mistake @ 5:02 you need to "massage" the bubbles out before you remove the 2nd layer, otherwise you'll end up scratching your screen protector with the card (trust me, it can happen, even on "scratch proof" protectors).
other than that it's a good tut, thanks!
Great channel. Picking up a second hand Deck next Saturday, and came across your channel while researching the Steam Deck, consider me subscribed!
Much appreciated! And welcome to the community. Let me know if you end up having any questions about the Steam Deck
@@SteamDeckExplained Will do! Thanks for the offer!
Thanks for the great video! However my installation went bad in every possible way. Even though doing everything meticulously and positioning the tray straight on top of the Deck, my protector went off to the left almost 1 mm. I ended up with a small bubble in the center of the screen which didn't move at all even though I massaged it couple of minutes. Also, it's hard to find a dust-free environment, so there's always some dust specks on top the screen which are trapped between. I tried to reposition and clear out the bubble by prying it from the corner, but it broke the glass (just the corner part). Best part of the installation was the fact that it cost only 20 € to try it and throw it to the bin. Don't get me wrong, the product was ok, especially with all the accessories included.
Thanks for the detailed explanation, helped me to setup mine properly :)
Would all the cleaning steps be necessary if the Steam Deck has only just arrived, fresh from the factory?
I've only opened the case in the past few minutes just to see it, but haven't taken it out, and re-sealed it.
You'd be surprised at what can get on the screen immediately after cleaning it (stupid fuzz/lint). So I would still recommend cleaning it and using the sticker afterwards
@@SteamDeckExplained
I ended up following all the cleaning instructions because of that reason.
I haven't been able to find anything stuck under the screen, so it appears to have been a success!
Awesome video, thanks!
Really wish someone would show the methods of removing a screen protector if ever needed. Everyone is just how to install. Plus idk how to tell if mine has any installed