Appion Core Tool Cleaning and Repacing O-Ring
HTML-код
- Опубликовано: 15 сен 2024
- I have to repair my Appion core removal tools. Nylog has gunked up behind the swivel connector. The gaskets also wore out due to, many uses this summer. Therefore I have to figure out how to replace the gaskets. I use alcohol to clean up the caked-on grease from nylog. Join me on my adventure.
I worked for a company that didn’t see the value in pulling deep vacuums. It killed me to be watch guys drip water into the piping during the brazing process then pull a 2 hour vac on large systems. On a few jobs the pressures went past 500psi on start up. Then the gas would be recovered, the micron gauge would be brought out and 1-2 days would be spent vacuuming out the moisture and getting the vacuum down to an acceptable level. Props to you for not following everyone else.
This hurts so much to watch it’s so simple to replace the o rings
Hello
Use a tooth brush
Next time its all cleaned up and about to get pressure tested to make sure new o-rings create a seal
@@billstools5244 harbor freight sells the plastic wire brushes and pipe cleaner
Yes I have to locate the gun cleaning brushes that come with the hand wipes. The also will work
@@billstools5244 walmart