Great video. You explain exactly how to build the model except for when you did the polar pattern of the pads you only did 4 instead of five in the drawing. I did 5 pads and it took me a bit to figure out how to get the drawing to pick up the fetors of the selection view and this is how I figured it out. With 5 pads only 1 pad is cut exactly down the center. I did a selection view, then used the tool to select external geometry. The problem with 5 pads is the R104 radios can only be selected on the right opposite side of the selection view. The top pad is selected on the left side. I just extended the top line pad all the way the outer edge with the external geometry tool. The make a R104 radius ark that is constrained to the center line and started the right point of ark, constrained to the external geometry line from original bottom of R104 radius and constrained the top of the pad horizontal line. Then made a line from my left pad down vertically to the R104 radius. I made a R22 radius ark and constrained it from the line that is connected from inner point of pad and extends the R22 radius ark down to the R104 Ark. I then constrained the other side of my R22 radius ark to the R104 radius ark at the bottom. Set my vertical measurement from top of pad down to R22 radius ark to 2mm. The horizontal measurement from bottom of the R22 ark, to center of drawing, I set to 35mm and drawing is constrained. From then on just follow video. I am not trying to correct anyone but only help those others with OCD like myself that can not stop until my task is complete. God bless and have a great day.
Thank you for the tutorial, I finally managed to model it with 5 landings and learned a lot of stuff along the way. Thank you again, and keep up the good work.
Great video. You explain exactly how to build the model except for when you did the polar pattern of the pads you only did 4 instead of five in the drawing. I did 5 pads and it took me a bit to figure out how to get the drawing to pick up the fetors of the selection view and this is how I figured it out. With 5 pads only 1 pad is cut exactly down the center. I did a selection view, then used the tool to select external geometry. The problem with 5 pads is the R104 radios can only be selected on the right opposite side of the selection view. The top pad is selected on the left side. I just extended the top line pad all the way the outer edge with the external geometry tool. The make a R104 radius ark that is constrained to the center line and started the right point of ark, constrained to the external geometry line from original bottom of R104 radius and constrained the top of the pad horizontal line. Then made a line from my left pad down vertically to the R104 radius. I made a R22 radius ark and constrained it from the line that is connected from inner point of pad and extends the R22 radius ark down to the R104 Ark. I then constrained the other side of my R22 radius ark to the R104 radius ark at the bottom. Set my vertical measurement from top of pad down to R22 radius ark to 2mm. The horizontal measurement from bottom of the R22 ark, to center of drawing, I set to 35mm and drawing is constrained. From then on just follow video. I am not trying to correct anyone but only help those others with OCD like myself that can not stop until my task is complete. God bless and have a great day.
Thank you for the tutorial, I finally managed to model it with 5 landings and learned a lot of stuff along the way.
Thank you again, and keep up the good work.
Hello good afternoon, the drawing shows five cutouts and your model was made with four maybe it was distraction.
Alot easier with 4, did you try the 5? hard to get the 22 deg fillet at bottom of protrusions, But 1/2 hr later I got it