Yea , it surges abit at real low revs , but when using the lathe you hardly notice if at all... range is about 200 too 4000 i think ... its also got a 60mm pully , so if you went down too 50 or 40 mm you could run it faster and avoid any surgeing......
ive got too go into the menu and hit 3 buttons too reverse , but there are a few on ali express that are set up for one touch i think........ this suits me and i got it local incase it gives any trouble
So, I can't tell for sure is the low-speed lope a 3/4 or full race cam?????🤣😂 What causes that or was I hearing things??? Looks like a nice upgrade!!
Yea , it surges abit at real low revs , but when using the lathe you hardly notice if at all... range is about 200 too 4000 i think ... its also got a 60mm pully , so if you went down too 50 or 40 mm you could run it faster and avoid any surgeing......
@@mohawkc77 Yes Sir I was just trying to be funny??? but as usual no one gets Me🙄
Is there now a solution that allows the directions of rotation to be switched quickly?
ive got too go into the menu and hit 3 buttons too reverse , but there are a few on ali express that are set up for one touch i think........ this suits me and i got it local incase it gives any trouble