Mercruiser Propeller Removal And Install DIY!
HTML-код
- Опубликовано: 5 сен 2024
- how to take off the sterndrive and install a mercruiser propeller diy
Amazon Link for purchase of 3 blade
amzn.to/3LyxlAq
amzn.to/3n2LGuO
amzn.to/3ZeJBcR
Stainless steel 3 blade
amzn.to/3Jutn9r
amzn.to/3JsXb6n
4 Blade
amzn.to/3FXA2rZ
#howto
#diy
#mercruiser
#boat
Thank you!!
Awesome thank you for watching!😊
Thank you
Awesome! Thank you and thanks for watching!😊
Great video thank you!
Awesome! Thank you and thanks for watching!
thank you. Going to change out my prop this weekend. Its beat up pretty bad and the vibration is getting annoying.
Awesome! Yeah it's pretty simple! Thank you for watching!👍😊
I took my propeller off, put a new one on and now it’s leaking the gear oil and it’s on there the same way. The old one came off. I do not understand it’s not being sealed what the hell is going on.
You shouldn't have any gear oil leaking from changing out the prop if you do it sounds like you have bigger issues! Can you see where it's leaking from????
Another good video
Awesome! Thank you and thank you for watching!👍💯😊
Thanks for the video. How do I know the size of my blade?
The proper propeller size for your boat and engine combination is based in part on the wide open throttle (WOT) operating range for your particular engine. You can find this in your operator's manual, expressed in terms of a certain horsepower at a certain r.p.m.
@@WhitehouseFarmVet thanks I will check the manual.
Yeah just in case you need the correct size for your boat, better to be sure!😉 hope you have a great summer on the water!👍
Helpful video man. Is the prop supposed to be able to spin both ways that easily when it's in neutral? Also, I'm hearing a small knocking when I spin my prop both ways.
Is that normal?
Yes when in neutral it will spin both ways , if your hearing a knocking or clunking you might need to adjust your gear cables because if its in neutral and your hearing noise which means it is trying to go into gear! Good luck and thanks for watching!👍
What was the grease you used to lube it up?
It's just marine grease you can buy it at Walmart! Thank you for watching 👍 😊
Which sterndrive is this?
Alpha 1 gen 1!
Which blade did you use?
They had 14.5x19 inch at my local Anderson boat shop, works great for my boat no issues! Thanks for watching!👍
@@WhitehouseFarmVet I tried a Hustler by Turning Point. I did a 14.25 x19 and the shaft was like a half inch longer so I hit the bottom part that looks like a skegg but it is not. I had to change it out for a quicksilver 14.25 x21 that sucked but I fixed it and it was great :) I will be testing out tomorrow I live in spring hill fl now :)
Nice, hopefully you will have a great time on the water this summer!😉😊