P0 to P5 Escooter LCD Settings / P Setting - Guide - Part 2 of 2

In this tutorial, you will learn how to configure the (P0 - P5) P / LCD settings of your e-scooter.
To configure the settings, press ‘Power’ + ‘Mode’ buttons at the same time this will direct you to the P / LCD settings as follows:
1. P0 (Wheel diameter in inches: 8, 10, 11, or otherwise; My setting: 10) - Press either ‘Mode’ button to increase the value or ‘P’ button to decrease
2. P1 (Low voltage protection cut off; My setting: 43V) - When the scooter reaches the specified value, say 43 volts, it will shut down or get cut off. This feature helps protect your battery. Press above mentioned buttons to increase or decrease value.
3. P2 (Units: 0-Kph or 1-Mph; My setting: 0) - Ditto to adjust value
4. P3 (0-Immediate Start or 1-Kick Start; My setting: 0) - Difference is:
(0) Immediate start - When you pull the throttle the scooter starts moving immediately from standstill position,
(1) Kick start - from the word itself you have to pull the throttle and manual kick first, scooter moves forward from standstill position, then scooter runs. Ditto to adjust value
5. P4 (0-Off/Non-continuous or 1-On/Continuous/Cruise mode; My setting: 1) - To activate cruise mode make sure P4 is set to 1 and pull the throttle for 6 to 8 seconds. Ditto to adjust value
6. P5 (0-Hard acceleration or 1-Soft acceleration; My setting: 1) - Hard setting is immediate acceleration when you pull the throttle, Soft is otherwise. Ditto to adjust value
My setting is abovementioned, however, you can of course adjust the settings of your e-scooter based on your personal preference.
Please do not forget to click LIKE and SUBSCRIBE to my Channel.
#Electricscooter #Escooter #Autech #XThunderDual #XTrack #Dubai #UAE #LCDsetting #Psetting #P0-P5

[@KulwinderSingh-q8t]

👎