Realy unprofesional! You must use a specialized tool for disassembly...... different from hammer :-) You reach for the hammer too easily. Given the cost of a new one and the subsequent adaptation.
hello I have the error Y3 / 8N1 (turbine speed sensor), I want to know if I can change the part I have to re-synchronize the box, and I want to know where I can buy. regards
Sorry to be so off topic but does anybody know of a tool to log back into an Instagram account..? I was stupid lost my account password. I would love any tricks you can offer me
@Kevin Walker i really appreciate your reply. I got to the site through google and I'm in the hacking process now. Takes a while so I will reply here later with my results.
looks like just regular solder type, nothing special there 🙂 Besides you really need a "temperature controlled solder-iron" (not the $5 one time use junk iron) - Nothing super fancy, as long as its the right soldering temperature it won't damage the fragile flex cable 👍🏻
Could you explain what happened in the car so you had to change this sensor?
Speed sensor i think
Shifts into gear really hard from park, doesn't change speeds
Realy unprofesional! You must use a specialized tool for disassembly...... different from hammer :-) You reach for the hammer too easily. Given the cost of a new one and the subsequent adaptation.
Good video
Is this a comedy? Did the car drive afterward?
Chinese sensor no good
hello I have the error Y3 / 8N1 (turbine speed sensor), I want to know if I can change the part I have to re-synchronize the box, and I want to know where I can buy. regards
😢
This will break the board and you need to replace the whole thing. Warning!!!!
If you make a hole on the bottom to punch out the sensor, do you need to seal it up?
There's a tool to remove them that works better
Parts changer I see lol
Hello, after changing speed sensors, did we need to set it up or to sychronise it by the star diag
Nope
Nope just clear the codes
Sorry to be so off topic but does anybody know of a tool to log back into an Instagram account..?
I was stupid lost my account password. I would love any tricks you can offer me
@Aiden Samuel instablaster =)
@Kevin Walker i really appreciate your reply. I got to the site through google and I'm in the hacking process now.
Takes a while so I will reply here later with my results.
How did it not break???
What type solder and flux do you use?
looks like just regular solder type, nothing special there 🙂
Besides you really need a "temperature controlled solder-iron" (not the $5 one time use junk iron) - Nothing super fancy, as long as its the right soldering temperature it won't damage the fragile flex cable
👍🏻
@@glasser2819 If you make a hole on the bottom to punch out the sensor, do you need to seal it up?
@@rusty358 one would think so... better not dismantle everything again !!
where is possible to purcase these replacement sebsors?
@@Transmission4less thank you!
hello friends what happens with the N3 sensor I also want to put new
Hello, I don't know neither. We don't have that sensor.