Видео

Hey 👋 I don’t think so but it fairly similar you will just need a wind back to to get the pistons back on the rear brakes 👍

Hey 👋 thanks for watching! I can’t wait either cos then I can have time to do even more content for everyone 😊

Hey 👋 thanks for watching

If you have a abs light on I would go have a code scan done to see what the issue is, it will tell you if you have a wheel speed sensor at fault etc, it won’t be anything to do with the brake pad wear sensor. 👍

You can get new seals but if the old ones are in good nick just reuse them and check for any blows after 👍

Hey 👋 yes they are a bit tricky, thanks for watching 😊

Hey 👋 well you can just top the coolant up and carry on you till the problem gets worse then you will have to do something. Who knows tho it could just last ages? Good luck 🤞

Thanks very much. This is the worst car I've ever owned. Constant issues. I'll never buy Ford again 😔

Hey great job 👍

Hey 👋 thanks for watching 😊

It Diego does work, I feel like you may be doing it wrong ? Pop it into your local garage I’m sure they can reset it 👍

@@MrAutoFixer I’m seeing the countdown but still doesn’t disappear

@Rudieas try it a few times, make sure all the doors are shut and you carry on holding the button ffor a bit after the countdown has finished then turn the ignition off and back on see if that works

I can’t ember exactly but it was either 40 or 50k on the clock 👍

Not for this car as we could see the water leaking into the bores which is nothing to do with the water pump 👍

Hey 👋 your welcome 🤗

Hey 👋 have you had any testing done on the car ? If not maybe pop it to a garage and have some simple tests done to find the cause of the leak ? 👍

There will be a small bit of fluid loss, but you could use pipe clamps on the soft pipes if you want too, but as you are going to bleed the system anyway it won’t matter if you lose some fluid 👍

Hey 👋 I’m happy to hear it 😊

Hey you would be looking at around £600 for the whole lot 👍

@@MrAutoFixer would the oil pressure fault be on all the time if this was the problem as it’s only happened twice to me and goes into limp home mode but fine again when I turn car on and off

@@stxduffer3974 as the problem starts the oil light will come on intermittently and gradually get worse as the strainer gets more blocked up best thing you can do is go have it checked or changed asap 👍

@@MrAutoFixer thanks it comes up with oil level low but the last two times today been saying oil level correct I have it booked in tomorrow to have it looked at

@stxduffer3974 yes best to get it checked before it goes bad ! Let me know how you get on 👍

Hey 👋 thanks for watching 👍

Hey 👋 thanks for watching 😊

Hey 👋 all I would say is when you get your one off make sure the new one is the same if not then take your old one to the parts place and get them to match it up from the part numbers on the old unit 👍 good luck let me know how you get on

Hey if the wires are no good then I would trace the wires back untill they are good and then make new wires 👍

Hey 👋 it’s a bit tricky but it can be done you just have to manipulate the filter into the hole but I’m sure with a few swear words and so scratches up ya arm you will get it done lol 😂

Hahah that good was it 😂

@@MrAutoFixer😂😂 a was buckled watching it. 🤔 wonder if viagra would pay you to turn it into an advert, "promo link" 💰 💶 💰

Hi mate as long as the car is looked after it should be ok and to have the belt done should be around £600 ish depending on who and where. You should expect to have the car back the same day 👍

Hey 👋 no problem I hope you get a good result 🤞 let me know how you get on, thanks for watching 👍

@@MrAutoFixer Yes, I've got a 2015 Ford Focus Titanium Ecoboost with the 1.5 petrol engine. Slight coolant loss over the last 12 months. Done the usual checks, dye test, checked the expansion tank. Nothing visible so when the kit arrives, I'll see if it gives me a result. 😎

Good idea, i actually have a video about coolant loos on the eco boost engines! Check it out The Mystery of Ford Focus Coolant Loss: Unveiling the Answer! ruclips.net/video/ZN618dNnuXE/видео.html

@@MrAutoFixer Hi, yes I've watched that video and it was very good. Pressure test is the way. 👍

Hey 👋 your welcome glad you got it fixed ! Thanks for watching 👍

Hi no sorry I do not but if I get one in soon I’ll Make one 😊

Hey 👋 yes some are very awkward! Thanks for watching 👍

Best thing you can do is regular services, and just take care of the car in genaral. Any fault can happen at any time really. 👍

Hey 👋 oh yes a lot of customers love using a steel seal just to get them by for a while untill they save up enough to have the repair done or a new car. Thanks for watching

Nice one ☝️ thanks for watching

Hey 👋 thanks guy or watching! I hope you get ya van sorted out, do let me know what you find and what you fix 👍

@MrAutoFixer This morning, i removed the vacuum pump. opened it, and sure enough, the vanes are destroyed. So, my boss has spoken to the owner for replace the vacuum pump, the timing belt, remove oil pan and clean all. 156.000 km on the odometer, 2018 M.Y. is time to replace wet timing belt as soon as possible.

@jokinusubiaga well sounds like the usual suspect ! Yh belt should be done at the same time as the rest really defo give it a good clean out! Good luck 🤞

Oi I did shower that day 😂

Hey I don’t think I have changed one, if I do change one I’ll be sure to do a video 👍

Hey 👋 the more you can clean out or replace the better really so if you can I would 👍

Oh savage mate!!! Hope you get it sorted out, let me know what you get done 👍

It could well be a torx head, maybe it’s not original ? 👍

@@MrAutoFixer yea looked on BMW Real OEM and its a M6 x 16mm torque screw, I'd rather a 10mm bolt, the torx screws always end up rounding off.

Yes that’s right, lots of people saying the same thing 👍

Is that the professional formula for wet belts now lol 😂

Hey 👋 thanks ☺️

I did mention that to the customer about the pulleys on these, but they didn’t want it done at the time 👍 but great advice tho 😊

That’s right 😊 I have plenty of videos for people to see the processes of lots of different jobs on cars👍 Thanks for watching

Hey 👋 thanks for watching I really appreciate it 👍

☝️👍☺️

Great write up ! But you’re right a lot of cars can take many attempts to complete it! 👍

Hey for that top cover I use elring dirko sealant great stuff, you could use most of the gasket maker sealants for that top cover and be ok 👍

Hi sorry you feel that way! The video is only 12 mins long not a 4 hour tutorial. Maybe you could make your own video on the process and share it 👍

Have you had it looked at by a garage ? Has it been on a pressure test ?

@@MrAutoFixer unfortunately not yet as I've only just noticed this past couple of weeks but I'll take it in tomorrow to get it checked 👍

@Spacebadger yes defo get it checked out and let me know what you find out 👍