Видео

Stupid video what’s the point of this video

Needs to be cheaper

Wish you had one for the 2015 Challenger, as the plastic cover over the 2015 is different enough, a separate video would be awesome.

Does it works with gen 6 rs?

I have a GMC 2015 Sierra, can this work for it and where can i get harness from?

For those who were confused like me, the red connector only comes out about 1/20th of an inch. Then you push in the small brown clip and red together and gently but firmly pull down.

Kris wright

Can the camera and mirror display be used with just power and ground or does it need to talk to a computer in the car?

Where does it route up and above the starter?

Have a 2018 Silverado. What fog lights do I need to buy that will connect to the harness? Not really understanding what I’m looking for when I purchase the fog lights. All of them say plug and play

Is there a function that allows me to keep those drl’s on at night (same brightness as day time) while also turning on my rear light (as if I had my headlights on) Pretty much the context that dodge uses for charger models at night

I recently had a stage 4 cam put in my Camaro 3 in headers Flowmaster exhaust. You think this would be helpful on my Camaro. Srry 2014 Camaro SS. LS3 motor

I just used this on a 2024 Camaro convertible. It does work, but you can't pull the upper console out like that, it seems the whole upper trim needs to be removed and there may be screws under tabs. I just didn't remove it and slid the USB adapter under that trim from the front. I also had to remove slightly the pillar going down, I saw no other way. Most of everything else is the same during install.

Can I know where to take the harness please?

I got a 2014 and all i got is headlights no fog lights i need 2 harnesses to upgrade to the 2018 led style right?

Crazy pricing

$100!! Haha I will just tap into the wire myself and save prob 80-90 bucks.

I have a 2010 SS....bad ground??? Never had a problem yet. 46 thousand miles.

Trying to use a ZL1 8 pin slot connector headlight in a 2019 LT that has a 12 pin slot connector on its headlight, do I just use the whole 2018 headlight harness?

It cranks no problem just not holding a charge

My issue is that I keep getting battery saver active and service battery charging system I replace the battery alternator any ideas what it could be

So I bought the harness for a 1/2 ton 15 slt to a 16-18 led headlight conversion but now without key on the headlights themselves won’t come on only if I switch on high beams. How do I fix that?

I was wondering if you would be making this for a 2020 convertible in the near future.

Can both harnesses (the dash cam and radar) be used at the same time?

Thank you brother, works perfectly on my 2018 Camaro ZL1

Man, mine took 3 hours haha

Great idea and product, but why is my VIN needed?

Any idea for cleaning condensation in front of the lense? a hair dryer?

I like but $100 is a no go for something that cost you about 47 cents to manufacture

Hey 5th Gen guys can your headlight wiring harness make the 5th gen headlights work on a 6th gen 2020 camaro LT 3.6L v6 ?

I have a 2017 1SS Camaro. I purchased a 2SS temperature control panel with the heated seat buttons. Does the wire harness need to be changed and is the seat wiring harness already installed?

Do the Silverado tail lights work on the Sierra?

Were can I get one for my 2016camaro 2ss with no sunroof

It'd be great if this was on a newer truck...so it would be easier to understand the connection to the trailer harness

Would this work on a Camaro lt 2015?

I just installed the Gen5DIY harness in my 2024 Silverado HD. I used the video here to give me insight about removing the plastic housing covering the wiring and electronics. Things are not much different from the earlier years. Everything connected properly and the radar detector works!

Thanks for posting this. I have a 2017 RS convertible and I had LEDs in my lights. Well the driver side has been flickering for a couple weeks when it was colder and yesterday it went out completely. Come to find out when putting the stock bulb back in it's blowing fuses. It blew the bulb also. As soon as I plug the light in and a fresh 20A ATR I hit the switch and pop. It blows the fuse. Which is really bizarre because I have not had any particular reason for this to happen. It'll pop the fuse even without a light in. As I have blown 4 fuses trying to figure this out. I don't know where to start or what is wrong but I fear I am going to end up pulling the bumper to replace the entire headlight. 🤬 I'll be going by this video. Thanks again.

Hey buddy any videos on how to replace the entire fog light no videos. What’s so ever in RUclips

Do you have the reverse of this changing led to the cheaper tail light sick of spending 670 dollars for a tail light

Suggest anyone with a car battery older than 2 years do a load check on it. I have had to replace two batteries thus far on my 2011 SS. I just recently put a Optima Red Top in my car and it helped tremendously. I am running a 400watt amp so that also put an extra load on the car. I will add the "0" gauge ground strap and see if the hard crank is completely cured which I suspect it will be. On another note, I have checked some of these "High Performance" starters that are actually made in China and the windings are of aluminum vs. copper. The darn aluminum degrades and melts down under heat. Pays to investigate the starter quality.

I wanna put this on my gbody

Does this help with a ground loop issue on the audio system when installing an aftermarket amp?

Can turn drls off or on running to the fog light fuse tap it of course. 👍😎

The drivers side headlight went out on my 2017 camaro do you have to replace the whole headlight or can you just replace the bulb?

why is a power wiring needed from the K33 HAVC Control Module when there is the same power source (Circuit 539) already in the existing mirror cable?? WHy this extra effort to route the power cable to the K33 HVAC Module?

why is a power wiring needed from the K33 HAVC Control Module when there is the same power source (Circuit 539) already in the existing mirror cable?? WHy this extra effort to route the power cable to the K33 HVAC Module?

Im curious for the 6th gen zl1 does that live rearview camera also work on the 5th gen zl1s?

I know everyone has to be looking for this comment because they didn’t show where the T harness connects to the light harness , pull out the connector from the driver side bed light and plug it into the female side of the suppliy T harness and the removed connector to the male side of the harness and do the rest as shown in this video and on the website once I figured this out it was a 10 minute install works awesome glad I did it there was no place to leave a review so I figured it would work here

Pretty sweet. But 100 bucks for a couple of wires is pretty steep. Costs more than the camera.

Was a plug & play install for me. Took about 10 mins. I rode about 4 weeks without my RD. Felt naked the whole time. I’m back in business now.