Видео

Mükemmel

Please advice with my Peugeot 207 1.6 VTi. The engine was running on 3 cylinders, I changed the coil and the next day it only runs on 3 cylinders again...

Great video, Helpt a lot.

☝

theres no way in hell i could have done the change without this video. the pug manual is just a joke.

Is there only one sensor on the car?

WHAT DO YOU KNOW ABOUT THE ELECTRONIC CONTROL SYSTEM WHICH WILL BE DISCONNECTED?

Untuk f56 apa juga seperti ini?

Untuk Oli menggunakan type atau merk apa? Tx

Horrible design... classic garbage Peugeot

Nm?

Missing to return back fromold unit to new Unit two fuses placed by side and not fixed by nuts.Check it and be careful when do this job.There are some better videos about this.There is solution if you have problem with mechanical relay you can ,without disconnecting +-pole, to connect cable with cable shoes on both sides (16mm2 cable) with additional nut and connect it from +-pole to fuse of 125 Ampers and you will get temporary possibility to drive your car.Originaly installed relay with electronic is usually short life relay.I did it untill I received new Unit.

I get a different code but check engine codes in and acceleration will not go at all or 10 miles per hour at best same situation

Mrs battery died and Geenflag came out and confirmed the battery was indeed finished. They had no spare on the van and halfords wanted to charge £40 to fit plus the price of the battery. Thankfully I watched your video and was able to remove battery as seen in your video but without moving the airbox. I then went to Europarts picked up a 70AH Varta and install. plenty of brownie points thanks to you and your upload. Many thanks.

Can I test to ensure it not a bad pin or wiring if I just plug in new sensor? Car doesn’t code p2122 came up. So car should start just by plugging in new sensor right? Do I really have to undo battery first?

Hello cik untuk peugeot 3008 P84 coolant pakai berapa liter

manipulation necessaire pour acceder aux ampoules H7

Thanks a lot.. what is the torque level for spark plugs?

The module ontop of the battery slides back towards the windscreen. And you can fold it out the way. Its wires go back to postive terminal. No need to undo the two positive terminals

Thank you so much for this video. I followed this for my Citreon C1 MK 2 1.2L. Exactly the same. Thanks again 😃

Hi??

in this car the wheel speed sensor is also The ABS sensor that you replaced? thanks

Didnt the gearbox is over filled with atf? The mid screw is for levelling.

Hello Sir. Thanks for your video. What would cause the fault when testet “voltage stabilizer” the engine fault comes when ECO is on. I turn it off. Faults i notice Are. Start stop does not work. Glow plugs indicator lights for 30 sec when ignition is turned on. Heavy start at times.

How to choose the measurements of the radiator, or even if they are of similar measurements, are they worth the same? ...also, disconnecting the battery being a start & stop, does it work by removing the positive, or do I have to do something else...I have a 508 sw from 2016. thank you

Can u give tutorial for changing,fuel pump and hpfp ? 🙏🏻

Y a t'il une programmation a faire , après le remplacement du BPGA?

Useful ❤go ahead!

How to replace vacuum brake booster

How to get the gas pedal sensor for the nissan lafesta mr20

In that year the 208 did not had 3 cilinders so wrong car or date ? WAKE UP ,!

Bonjour. L ecope d air a eté modifié a l entreé. 😊

Music is nice, thanks for the info! I have a 1.6 vti too

is there a specific brake fluid for peugeot 508

which kind of fluid to use for peugeot 508 2.2 2011 ? and is it the same proces ?

aerodynamic parts not included

No matter what i try i cant seem to get that first connector off

Great vid, can the filter go in the housing any way around? Thanks

Could this be the cause of an electical curcuit fault which drains the battery after 2 days of none use. Thanks

Halo bang.. Boleh tolong bagi sy faham Beside Total LV MV. Apa lagi minyak transmission comply Jws 3324?

Thanks for your video. Please, should i change the transmission fluid iñ my Peugeot 3008, 2011 model, though the car manual said dont change the oil? I have 60000mileage on the car, and i am having incorrect gear ratio - P0730.Pls, what should I do? Thanks in advance.

If you cant tell the difference between pads and brake discs then you arent going to be helpful

Is that 2008 the same way to do it? Thanks a lot.

hi, i took of like an idiot the nut covered by the orange tape, when re fitted I now just get 1 click when iu try to start the engine and no lights works, any ideas? could that just be a blown fuse

Best engine ever.

Hello, could you make a video of how you change the oil in the differential of the 308 GTI? Nice videos!!!

Should the engine start when bleeding ?

does the 2017+ 3008 have an undertray with a million bolts in the way of the sump?

What a terrible design stick to ozzy and us and uk design cars what were the French thinking

Really good video, thank you. Made the change so much easier.