Видео

Can a bad shift solenoid cause no movement to

What controls reverse in these things?

I would seriously consider finding a new camera man.

what kind of pump is that?

2004 grand marquis is the same transmission sir??

where are you located.

Do you usually change the differential carrier bearings too when rebuilding these? How do you check to see if that is needed too? (Not sure if this is typically needed for Honda/Acura Automatic Transmissions)

Yeah please pinpoint the problem--that's the whole point of the video

Want to know if the front pump on a 2005 can work on a 2007 f150 also ?

25 bands!?! Bruh… I feel bad fr for that man

25k ain’t know way if he did he is sore from the fucking

Is this exact same for 2005 Pilot AWD?

The bolts that mate the bellhousing to the engine also thread into the two oversize threaded holes in the pump housing. You can tune in tokyo and pull it by hand or slide hammer on the head with light taps.

So what would typically cause the 2nd brake splines to wear down that bad?

For this transmission , what wasn't included in the rebuild kit that u used, and what did total parts cost come to?

How much does that usually cost I have the same issue no reverse or 2nd it just revs to the moon and shifts straight to 3rd

Very good information. 👍

Im

That was amazing dude!

Whats the cost? My 💩's going out.

Can you confirm every part can swap out with the GMR diesel transmission except the gears? You mentioned "the groove for the snap ring is a lot higher in the diesel" is that part one of the gears? I assume that is because the clutch pack is thicker, but is there a higher snap ring groove included on all ZF5hp19FL?

Is it a torque converter transmission?

That’s a 4R75E bc a 75W is a wide ratio transmission and only has one speed sensor on the driver side. The 75E on the other hand has two speed sensors on the driver side as you see on the transmission in the video

My 4l60e was rebuilt a little over a year ago and here recently it all of a sudden had no movement. I dropped the pan and didn't see any metal debri or shavings at all. Your video has me thinking it could be the pump. The fluid level didn't drop after cranking either.

25k piece of junk

It's to bad you decided to throw parts at it in the video like every other shop that built it. If you did find the root cause you most definitely did not explain it or show why. You had a great video up to that point.

Randy's transmission by the look of the red?

Great to watch. Made me miss working in a tranny shop. 👍👍

Horrible trabajo, utilizas mucho la grasa, pones en exceso y en lugares donde no deberías poner . Y dónde deberías no colocas grasa. No das torque específico y se te olvidó poner un check 😮

Dumb ? How do you tell if it’s the deep pan or shallow or then the obvious just looking At it ?

I’m having trouble finding a pump for a 4R70w

Great video, do you actually do this as your job, or just hobby?, I really need to rebuild my Honda transmission

How much you charge me to rebuild my 4L60

Did it have a check ball in both the drum n piston? It was odd it didn't air check right with the drum in case but did fine outside of the case. I would replace both the case and entire drum. Or I would have had to find the exact problem.

That big snap ring was in the middle of the opening. It's not supposed to be like that. Should not be in the opening.

Piece of cake!

He never did diagnose the lack of reverse!!

That guy got ripped off big time

Got you a sub. Great video. Gonna be tearing mine down in the spring. No reverse and I'm debating doing the whole rebuilt. How much does the entire overhaul parts kit cost for the 4L60E?

Apparently a transmission rebuild is not an actual rebuild. I thought all of the internals were replaced, hmmm?

Looks like a Randy’s transmission

And what other Honda vehicle comes with the BGRA transmission

Hey is the clutch plate and Steal the same in the BGRA and byra?

Great Video! I have a 2004 Honda Odyssey with a bad one way clutch (sprag style) in its automatic transmission. When coming to a stop it sometimes doesn’t engage but I can get it going with putting the gear in low or 2nd manually. I’ve been driving like this for 1 month. How long do you think this one way clutch failure can last ? Will it get worse and ultimately fail ?

wow, squeegee is a good idea that I can use

why youu use too much grease to lubrican automatic tranmission...??

I had a 1998 Honda Accord with the Baxa transmission and I drove it over a year with slipping gears. When the engine was warm it would shift normally, but when cold you had to shift to neutral then back to drive like a quick flick and it would upshift. It was kind of trippy when someone would be in the car and ask what are you doing. I say I’m shifting lol. But it’s an automatic? Yeah but it’s a Honda so…

Bad ass!

Hola soy de España,tienes una caja entera para vender? O solo piezas? La mia es 5hp19 de porche Gracias

Where do you buy the rebuild kits?