Видео

The only thing I would have done differently would be to use robots or put rubber washers or o-ring under the brackets on the a pillar

I have a 07 truck with the o2 sensors on the manifold, if I took the insides out of the cat would I need to tune the truck? Or could i get away with just gutting it and running it 🫣

So after all that you been throw, did you re-install the catch can or leave it out? Also has the boomba blow off valve cause any problems or affect anything long term that you can notice?

just remove the wheel will liner.

What exactly is needed to swap a 4.2 into a 2007 canyon? It has the 3.7l and it is 4wd. We can ditch the 4wd if needed. What year trailblazer motors will work?

Can you do a video of installing a three prong outlet in the bed? I recently bought a 24’ Colorado lt and I see a spot on the right side for it because it comes with the spray liner package but I didn’t wanna pay the premium when I know I can get it for cheaper.

I cant stand those rediculous ricer car blowoff sounds …that and bagpipes 😜

Good information! I removed the 2.8 from my 2006 Colorado and installed a 2004 3.5 into the truck and now I have a PO315 code and the truck starts runs for two seconds and dies. The only difference that I have found is a two wire plug between the battery and the fuse box. The 2004 3.5 has a 3 wire plug and the 2006 has a two wire plug. I may swap the entire dash harness out so everything is out of the same truck. Not sure what to do.

Yea!!! Go GM. Love mylifted ZR2 I didn't like the windcomander.

there is abnormally amt of leafs on that truck

Awesome jack. Built one and love it.

My 04 i5 engine is still running smooth but I'm 220k and it makes me nervous thinking about it just dying one day.

Are those light bulbs replaceable? Mine don’t turn on, on any of the doors.

Where does the fan go?

Yes Sir my pops bought one of his long from elementary school friends 08 Colorado that he bought new got 138k straight 5, reg can Z71 4x4 off-road package. We got it for 8 hundies . Put 2 new back shocks on it one was plum rusted off ring bolt goes through rusted in tó. Hauled good bet of regrind asphalt and gravel a good bit. But my buddy took his loader up on hill behind our houses and found some red dog from coal mines.akes great road . Look pretty to boot. But anyway two miles back old tram road rough tram road he had his dad's old first year t100 4x4 and my Colorado well he put ton and half on his and I'd say last scoop of Massey Ferguson loader like 1040 series decent little size . It done leaf spring hanger in or off should I say I did make it home unloaded and next day me pops going on hill look for any turkey sign and that's when we noticed it. He drove and said I feel like I'm looking at the sun. Lol. We got home and I noticed she sitting low driver side. Well shackle was always flat horizontal in back and front hanger rusted busted and ripped off. Getting the bed off and going redo the bad spots of the frame and hanger mounts. . Love the channel ole buddy. Thanks for making and sharing these videos. Stay safe from ur ole hillbilly buddy

What winch did yall use. The link you used was for the light bar by accident.

I wanted to swap it out for the 4 cylinder diesel from the 2017 Colorado

Couldn't this void your warranty?

Boeing be like:

What’s part number on that’s hitch from gm I call my dealer order it with vin number it has 2inch receiver but when I pick it up it say 3500 pound trailer the number I order was 86796043 is the 7700 llb 23 z71 2.7

What’s part number on that’s hitch from gm

Thanks for this video! It was a perfect free fix for the problem.

Hey man it clearly adds Smiles Per Gallon

Wish you would have showed how you connected the wiring to the auxiliary button.

Thank you I have a 446 I’m gonna try that cleaning first before try replacing the vent solenoid or the fuel tank pressure sensor

That sounds is priceless

Thanks for the info. This problem has been making me insane. It works then it doesn't. Yes, I will rock a sticker.

I put a 5.3 in my 2006 Canyon. Building it for drag racing. Video on my channel...

My aux switch works inverted plug in the bed.

I’m the same. I can’t leave anything alone. 😂

Can this thing be installed on a small, unpowered turbo engine with side mounts?

Did the Lasfit light bar install vid ever come out?

Is that oil or condensation/moisture?

Works perfect!!!! 10/10 🎉

So true!

Ive got a 3.5 thats knocking that i need to get rid of but hate to throw it away!! Anybody that wants a core I'm near Billings Montana

That's a premium upgrade

GMC: so we got an amazing new truck we just designed. Releases a replica TRX

If you made it on that plane leave all ts in the past and look at every one in that position as your next boss idk you you might be rich me personally I would try and play my cards and get in good with the plane folks

They all want to be like ford

As an Oregon duck fan. I need it

Lol yes please

Great video, i ran into the same issue and did the same QD fittings but i used an “open” QD. Check them out and it takes a lil stress off the lil pump

A first Mod, Thank you for pointing this out.

Did you make some brackets?

After watching your video I had to go check my truck it seems strange but on my Colorado zr2 they are on the top of the frame not the bottom like your canyon

So your bumper is rated at 300 lb

Yeah man let's get that kit going. I would love to have that in my colorado!

Will it work on true dual set up?