Видео

It would be nice to have a video showing how to change the oil that's in the torque.

I did exactly what was done in this video. Why is the engine idling weird??? Like it feels like it wants to stall but doesn’t

What is “a number 7” exactly? Because my 7mm ratchet isn’t grabbing onto anything…

My 2015 X-trail run 200k and still i didn't change it, when I checked Nissan service center, they said CVT transmission oil no need to change, now I'm confused.

And how much does that one more time cost sir?

Thanks god bless you

For the slide-pins, I have found that using a Q-tip/cotton swab and putting the anti-seize INSIDE the rubber tubes (sleeves? don't know what they're called) on the caliper works better. When I put the anti-seize on the slide pins themselves, it would all get wiped off the pins when I inserted the pins into the tubes. So putting the anti-seize inside the tubes first would get better coverage and the pins would slide much more easily.

does anyone know if the transmition change for europe? Especially for 1.7 dci diesel

What time is the championship race

Niceeee

I took the actuator off even when I put it in service mode lol now I can’t put it back on, how do I put the actuator back on?

Great video. Thorough!

In diesel b 180 cdi is the same? 2007

I'm about to get an 08 Silverado. This looks very easy!

I sure do wish you would have done the installation with the removal.

Thank you so much. I’m 60 yrs old and changing my oil for the first time. 😃

Very impressive and helpful video

How much would you charge for a job like that?

Good job buddy definitely very informative

Thanks a lot for info👍

Waist of my time ..

Huge lifesaver. Truck died in drive thru with a trailer. Ended up being the plug under the dash, it wad halfway out

I lifted from the oil pan thinking it was the lift point and dented it... For those of you watching, be careful.

❤

Yes sir, it was very useful and informative and really appreciate your time to teach us how to do maintenance to our car. Thank you so much.

Thank you so much for your video and tips. It was my second filter change this went much better. It’s still a tight spot!

Thanks for the video..!

Are cvt like regular trans if they dont change fluid regularly dont do it or risk of damage

Fram filters are terrible filters. Research them and you’ll see.

What kind of oil you recommend and what’s the amount it requires ? Awesome video

What if the caliber doesn't collapse

Did you have to remove the center console plastic section to gain access to the part your video shows. I see the plastic vent on the center console going forward to the gas petal , looks that that may be in the way, or is it? I have no problem taking off the section under the steering column ( obd port and hood release) I can do that, but can you even see the actuator with just the pieces removed from under the steering column as in 9:38 of your video? Thanks it is a very good video and I have a new part to replace the old damaged one.

You fuckin saved me it was my problem 💯

Very helpful and informative! Great video my friend.

How long does it take to change transmission gasket in 2013 acura rdx?

What a stupid design, I spend over 20 minutes putting the damn thing back in. Thanks for the info

Thank you. I'm thinking I take a 4" hole saw. Make a port for the filter and the screw. Never take those 17 screws out except that first time. 😂

Thank You for this video I had the pleasure of doing this exact thing to my daughter’s car and it worked so well I will be watching more of your videos and hitting the like button Thanks Again Walter Clark

You really should have a disclaimer somewhere in that video that you are showing people how to violate federal law by installing headlights that were not approved and or manufactured for those housings in particular and as a result may end up getting them fined and possibly making them revert the lights back etc. what you are showing people to do is illegal in every state

1:38 (#7 hex/alan key)

Filters?????

Hammer n prybar for filter

Very helpful video! Thanks for posting.🙂

Oil change simplified. Thx

Man you saved my ass. Thank you 🙏

Awesome video! Thank you for taking the time to explain this.

Hi Jay. I am hoping you read this comment soon. My question is related to the brake job once the maintenance mode is set in place using the scan too (which I do own one that that can do this). Once you begin the brake job are you still removing the electronic parking brake from the caliper? I assume yes. So the only thing the maitenance mode does is remove the need to manually turn the plate on the back on the back of the caliper with a torx socket, correct?

Thank you for this video very great information

Thank you for this video!