Видео

Great review and comparisons! Let's see reviews of the Skywing 48" and 61" PNPs. For good measure, throw in reviews and comparisons of the Extreme Flight 60" and 67" RxRs!

Very accurate comparison!!! I have the 102” Skywing ARS 300 and feel like what you observed about the ARS applies to the 102” size. I’ve also heard of others saying that the wing shape of the ARS is good for IMAC.

I am not sure about using loctite, its non conductive so by using it its causing a non conductive contact area between the screw and the connector

Very good detailed comparison video; I’d love for the first few sentences to be this plane cost:…… And this plane cost:…..

Is it safe to say that at this scale you can now get the same or better thrust to weight ratio with electric? That looked pretty capable to me. Trying to find where the crossover point is in aircraft size where you no longer get better thrust to weight with electric.

Great build demo. !! Question: Were all the servos and receivers powered by the ESC's BEC ? I.E. No separate 2 cell lipos were used to power the servos and receivers ? I want to build a similar size 3D electric and I'm concerned about what is the best way to power the control system?

Thank you so much Kyle !! This really helped me. I was trying to do throttle calibration with a Scorpion II 06-120 and a Spektrum DX9. I couldn't figure out why it wouldn't work. I used your trick where you power up the RX first. I used a l2s lipo but it goes though a old Align separated box to power up a RX with a lipo, so its only outputting 5.8V. I use it all the time to power a servo tester. So I powered up my AR637T first waited for it to initialize. Then put the stick to 100% (throttle sub trim at 0, linier throttle curve, enabled to the throttle stick) plugged in the main battery and I heard the beep, lower the stick and hear two beeps. un plug. Done. Now return the throttle sub trim to -100. Finished. THANK YOU !!

Nice flight and very good flying plane for being electric powered. Love the sound of the prop when you get on it, almost sounds more like the real full-sized aircraft. The prop really barks.

Which engine should I use in a Juniaer A29 Super Tucano model aircraft that weighs 46lb with a 24x23.5” five-blade propeller?

Awesome flying. Quick question could you get the same performance from using 2 6S batteries? I know you said you use 1 big pack. What 2 6S would you recommend to get the same performance. Thanks

Awesome flying. Quick question could you get the same performance from using 2 6S batteries? I know you said you use 1 big pack. What 2 6S would you recommend to get the same performance. Thanks

🦂TOP🦂

Hi Kyle Dahl, really nice informative video, thank you. May I ask you something, what device do you use for balancing the rc aircraft. ( I hope is not the finger method) Thanks Angel

Can you buy just the case?

What size of bullet connectors come installed on motor?

Is the thin ZAP CA you're using Foam Safe?

Just to clarify, is the esc pre soldered with a battery connector, or are only the bullet connectors for the motors pre soldered? Just wondering because the photos on the store dont show a battery connector on it. If it does come with a connector, what kind is it? XT-90?

Hi, for a 84" 12S PilotRC Slick what motor, kv and prop do you recommend?

I am preparing a 114 inch airplane with the same motor. In the video, it appears that an electric propeller is used. Is there any problem if I don't use an engine propeller? How did you attach the electric propeller to the engine hub?

The most important factor you never mentioned is your radio and receiver setup. If you are using vbar then try something else for a fair comparison

Awesome review Kyle. Would love to see a review of the 67” ng as well. A 3 plane comparison would be spectacular! I don’t see anything else like this on RUclips and would be a great help to us who are only going to choose 1 plane.

Very VERY Nice! Well Done !! Would the StinGR gear reduction give and advantages?

Do you still have that bueatiful BVM edge that was on that back wall and would you like to sell it?👍🏿

What packs did you use ?

Amazing flying 🎉🎉

What about those does it come with the screws to bind them to the bullet connector?

Hello nice review, I really like the ARS300, but I’m not a 3D pilot. Do you think it’s worth to buy it just for sport flying and do some basic maneuvers like rolls, loops, inverted flight and some knife edge…..thanks

I have the tribunus 06-80A, programmed and installed in RAW 420. On Sproto it shows the throttle goingb from 0-100% but no power to the motor. Also no beeps at all. But i have a solid green light. Any suggestions?

What a beautiful plane 😍 very well put together and thought out the best I have seen hands down...

I fly 3D mostly in electric but wanted to get into the 120cc class and I always get told go for gas power, but I dont want to the hassle of gas. This setup gives me hope. Is the power system already on for sale?

good to see you warming up to fixed wing. Those heli skills are a big help, I'm sure. Are you planning to compete or have you been? Either precision or freestyle?

Always Mount speed controller on the right side of the motor box for maximum Cooling & do not run air ducts.. .

If it ain't electric it just ain't. Electric power just has too many advantages over glow or gas!.. .

That was not a hard flight. I'm not surprised it wasn't hot. Get on it for the entire flight then give us the temps

Great video on the comparison. Loved the build overview and flight comparison. Personally I wouldn't need the aerodynamic comparison. Thanks for making this video. Must have been a ton of work. I'd love a comparison between the Edge and the Extremeflight Extra NG.

You can just let the tail wheel swivel. On some models I prefer it actually

Hey Kyle.....I'm starting to think you were a fixed wing pilot before rotory wing. Am I right?

This is a great video. Very informative. I love this set up! I am saving for this plane. I hope it is available next summer.

Great system

Very good video

So awesome great flight

A lot of adjectives to describe it. I notice 'affordable' wasn't one. Lol I'll work my way up. It's going to take a while before I feel I "deserve" a plane this grand.

Do you ever use receiver redundancy (2 Futaba Receviers) in one airplane and if so which receivers work best and at what size do you do this?

I'm glad to see this size plane with electric power. I'm pretty much done with glow and I've never had gas.

Wow! At first was watching in suspense for flight time, and was so surprised when you started into a 2nd sequence! After that thought, "ok he's got to land." Then you went back and flew 3-4 more maneuvers!! Just wow. Thanks for demonstrating that Kyle

Running the Pro PNP Combo on a 60" AJ Laser at 4,800 - 6,300ft elev with Falcon 17x10 Carbon prop. Outstanding power and only 90A max at full throttle. Love it!!

Does this fly with 4s lipo? i have a few 4s 2200mah lying spare

Well I definitely did. Sounds pretty amazing. Let’s see how it works in my Pilot RC Extra NG 67” 😊

hi Kyle, I've just purchased the tribunus 11 60- 120a, should my throttle trim be centre when calibrating? thanks in advance

Hey how many kv is recommended for this plane? I see this motor also in 180kv