Видео

"Smells like China." Say you're a Trump supporter without saying you're a Trump supporter.🤔

We had a 1978 Chevy caprice classic wagon. It was a very good car with 305 engine. Got 21 mpg hwy. power everything. Good ac with the long compressor.

Have to make sure you screw into the bottom cord of those trusses. I was thinking about screwing in 1/2” osb to bottom cord of trusses after they’re in layout. Then quickly screw the corrugated metal sheets to the OSB, more rigidity. But raises cost. That building should nice and warm. 👍 Good job guys.

Its hard to imposible to replace a sheet of side steel if it is directly sprayed. Not that it would ever get run into and bent. Dont ask how i know

Why not hang the foam board outside of the post and beam ,overlaid with the metal siding....longer fasteners are worth the results....

Bugs do add R value for sure lucky we live in Texas

I use a table saw for ripping the foam and getting perfect straight cuts

Cost aside spray foam is probably the best type of insulation to use . Until you have to make a wall or roof repair , and wood or metal panels need replacing . What will it cost to have a spray foam installer come back to spray a small area ? I know they have those kits you can use , but I think the way you guys did it is the way I would go too .

WIt till you get around to building a pontoon boat with foamular.

You sound like Red from the Red Green show! 😁

I am confused. At about 4:15 in the video, you talk about using spray foam would hide a roof leak until there is enough erosion that would cause a catastrophic failure. Since you are using closed cell spray foam which would not soak up the water allowing it to sit there compared to open cell spray foam which would absorb it in comparison, but neither would really cause you enough erosion for a catastrophic failure if you are using a proper metal in your metal building/roofing. That is more of a wood issue than it is a metal issue.

Well I got a 40x60 with 14 foot ceilings in the upper peninsula of Michigan. So going off your math I will need an only fans the go the cheap way😂

Yeah they have their highly opinionated review of this generator while I have my review of this video.... this is the definition of Idiocracy

Price?

Pick a medium sticks or a for real steel building, when we insulate as we sheet , R40 roof, r25 walls

What is the best company to order 2 or 3 inch closed cell foam insulation for a 14X 16 shed? I live in central North Carolina. I have Lowes and Home Depot but is there a wholesale outfit that is better on price?

It needs to have fender skirts on it and whitewalls and a white top

I have run a couple of refrigerators and our house's heat pump (soft start installed on it) in air conditionig mode with the 9500. It would never have run the heat pump without the soft start because in has an lock rotor current of roughly 90A, and the soft start gets it down to 18A. I will be getting a second one to run in parallel--we have an all-electric home.

Hollywood leftie cowards love fake news and spreading them.

We are going to be at this upcoming car show on the 30

I promise you that silver 1969 road runner is my dad's

Martinez Maria Miller Margaret White Laura

Hey guy, after a year now, are you having any problems with condensation between the installation and walls? If so, what would you do different?

Ever sense 2020 ! ALL three trucks are better then todays newer trucks with def!! If I could and had the money myself I’ll buy all three!

Don't know where you getting your prices but one single foam board 4x8 ft 3 inches thick costs over $100 bucks so it would be astronomical to cover that shop area. I keep hearing it's so cheap and been looking everywhere online and home depot and I don't know how or why anyone would even consider or afford a shack, let alone a house.

how is ESP vs XPS for this type of insulation

The only cummins i like is cummins cider ...😏

Very dumb to use the blower do you want to remove the dirt not just move it all over the place dust pan broom and then the shop vac no blower

Im trying to decide what to go with for my future project. It will be an 80x60x20, but it needs extremely good sound proofing / absorption for all walls, including interior walls. I'm trying not to overspend, but I need an stc rating of 50 minimum, and even higher would be great, lol. I suspect this will cost a fortune, though.

The inductive load of a 7.5 HP motor is too great for that generator. You chose the wrong generator for the task.

Pretty sire that should have been put on before the metal roof. I feel like the moisture will rot all your woof above that level

Thank you for the video. It helps a lot to have this information.

1:50 $2500 of foam vs $16,000 of spray foam is not 16% less. so whats the actual cost you were paying? its stupid youtubes like these that make me hate timewasting BS videos like this

The part I like about this Video is how you make it so easy to lift those sheets!

Add a soft start to theses devices. The large air compressor is way to big.

You should have went with rockwool/mineral wool because of insulation/fire resistance and even sound proofing all in one. Sprayfoam is a fire hazard

The two of you make me miss a friend I have had since 1985... good times working together!

Great video guys, who's insulation did you use?

Motors have a start up amps, that may go higher then 30 amp at start up.....

What about the moisture between the steel and that barrier?

That nifty 50 on that pole looks super familiar did that come from michigan?

These guys should have their own show, hilarous.

MUCHAS GRACIAS JOVENES POR POCO Y COMETO UN GRAN HERROR DIOS LO BENDIGA TENGO UN GENERADOR 8000 DEWAL Y ME QUEDO CON EL GRACIAS DE NUEVO NO VOY A GASTAR DINERO DE OQUIS SALUDOS DE MEXICO

I contracted closed cell spray foam on my 40x60 barn. Gables and ceiling (open truss) was sprayed with 2 inch closed cell. I had them spray 1.5 inch on the walls. They also painted the ceiling with fire retardant spray. They also painted the trusses flat black to match the ceiling. Total price was $15,000. It is awesome. I do have a HVAC system but only use it 1-2 hours a day when I’m working out, playing pool or watching games. I plan on adding 2 x EG-4 DIY solar minisplits. These would run off solar only but have the option to draw power from the grid when desired. I would let them run nonstop during the day from sun power. To save electricity I heat it with a fireplace in the Tennessee winter. I get the temp almost 70 degrees on cold days. Here is a huge advantage I found with spray foam. I run one 100 pint Dehumidifier with pump I bought from Lowes. It keeps the humidity around 50%! I suspect it can do this since the barn is sealed like a cooler. Leaks! You made a good point. However since the closed cell sprayed is painted flat black I was able to see where the roof was leaking. I would see white stains penetrating through. My son jumped on the roof and I talked him over to the spot. He found loose screws and tightened them up. I believe we found about 5-7 leaks. Great video. Thanks for sharing.

Need a 50 amp splitter and both 30amp plugs to get the maximum benefit of the 9500 which has a max output of 63 amps...it will run the air compressor and welder..no problem. You guys should probably have a professional handling your work for you..😅😂

For a 35x45 shop with a ending total of 3,337 square feet of wall insulation needed I end up needing 104 sheets of the foam board totaling to $12,200, The price must have gone up a bit.

The rigid board ( as well as the spray foam) require interior thermal barrier ( 15 minutes) per code and cannot be left exposed. You either cover it by drywall or spray it with E-84 fireguard coating

I have a 5500 Coleman running for 3 days on my place 100' extension cord just my freezer my refrigerator 2 battery chargers and 2 shop fans and my little air compressor (occasionally) Then on all the way to the back property 300' away my in-laws their refrigerator a freezer and a fan. And chargers. Wires didn't even heat up worked great. I was thinking of upgrading to one of these but I think I'll keep mine. Upgrading to something better.

Well you're wrong about the leaks and spray foam.. the foam adheres to the metal so it's not going anywhere. And what's with that foam adheres to that metal. You'll never be able to pull it off..

Well Iam very disappointed with this item Iam in TX bought this thing a month ago now I just using it and only has my refrigerator plug in to it and it’s keep popping out every like 15 to 20 minutes very (f) disappointing after I spent $2000.56 dollars at harbor freight last month