Видео

I love you sm for this video!!! Thank you so much, you're a life saver 🙏

Mine is a making a loud buzzing noise

Life saver! Thank you! For sharing! 🙏🏼🤜🏼

How long you should wait

What if you do all that and nothing

What if no lights light up?

I literally think the chain actually broke ? On my ram

What if its not on senseing

Ha. Here after work....3 am CST....thank you for this

I take it the chain cannot be changed with the case on the truck?

I love you!

Mine won’t light up 😢 every video says this but nothing

i cant figure out how to get this machine to go. i pressed start, it fills the machine for 4 seconds then stops. Help

Hell yea

how do you know when the 6th cylinder is at tdc?

Mine didn’t work 😢

Thank you , I hate these washers wish I had a old machine 😢

60mm or 62mm on the replacement?

Thx a bunch! Never knew you had to do this and it solved my problem

How do you clean filter?

Thank you for sharing this 😊❤🎉 you saved the day!!! God bless you

Very good video. Thank you. So helpful

Omg thank you. I've always had to just start the load over, lol.

What else is there to do after all the lights are done and you put a load in and it does it again. So AGGRAVATING ,BUT I need to wash

Thank you so much! I new the basket was tight so I did what you said and spin cycle is like brand new. No shaking or loud noise!!

Thank you so much for this you are an angel

Thanks for the video. Replacing mine tomorrow and this will help.

Thank you so much😭😭

Thank you!! It took a couple tries but it worked!

Thanks you!! It worked for me

I’ve done it like 4 times and still when I try to start the cycle from the beginning after the calibration it just fills with water spins then drains. Basically the sensing fill portion then stops once it supposed to begin washing.

How long does it have to calibrate for?

I love youtube

Yes good indtruction. However i have seen some do 3/4 turn past zero lash and you are doing 1 full turn. I suppose either will work fine

Didn't work have an Amana

How many are there

Thank you! It work for me .

How long does it take to calibrate? What should it do or sound like?

I swear to god I did this on the FIRST TRY and it worked! 👏🏾💪🏾

This video saved my marriage.

So thats what all the 80s and 90s game programmers have been up to. Writing cheat codes for appliances

Ok i did it and it recalibrated. But the lid lock light is still blinking

My old washer I never had to do such mess.

I did exactly it had light up when taking in water it suddenly stopped so it’s stuck with water I don’t wanna give up

Somebody tell me what I’m doing wrong cause this just don’t make no sense

You're my hero Just save me a lot of money and excellent video.

Go to the left from where ? From straight down or where you had it on rinse ?

Can I use rule of 13 in that? it has 12 valves right? in a 4 cylinder they use rule of 9 because it has 8 valves

And the nice thing is you can do this with case in the jeep.😃😃😃😃

Thank you, thank you, thank you!!!! I was about to lose it. Trying to figure out what to do!!