22/03/22 I've been teaching myself small engine work for the past nine months and am compiling a complete diagnostic process worksheet so I do things in the right order, avoid testing when I don't need to and make sure I don't miss anything. I've searched for and found every video Joe Pace has posted in an effort to assemble all the diagnostic information available for the "Advanced Sequential Troubleshooting Worksheet" (which was mentioned in every video but which I cannot find anywhere). I have seen six parts - F (two parts), G, L, I and O plus the Block Off Plate section but have not found Section H or a copy of the entire worksheet. If anyone has more information or even just a list of what's on section H I'd be most grateful. I'm posting this on every one of the above sections in hopes I'll finally get the attention of someone from Husqvarna like a servicing dealer who is willing to share that information.
When adjusting the spark length to indicate the coil power condition if moved too far the spark will jump to the third point . On two point testers it may seek ground back into the module possibly shorting the module out . 1/23
22/03/22 I've been teaching myself small engine work for the past nine months and am compiling a complete diagnostic process worksheet so I do things in the right order, avoid testing when I don't need to and make sure I don't miss anything. I've searched for and found every video Joe Pace has posted in an effort to assemble all the diagnostic information available for the "Advanced Sequential Troubleshooting Worksheet" (which was mentioned in every video but which I cannot find anywhere). I have seen six parts - F (two parts), G, L, I and O plus the Block Off Plate section but have not found Section H or a copy of the entire worksheet. If anyone has more information or even just a list of what's on section H I'd be most grateful. I'm posting this on every one of the above sections in hopes I'll finally get the attention of someone from Husqvarna like a servicing dealer who is willing to share that information.
Old rule - blue is good, red is dead.
Securing the product down on a table with a ratchet binding strap helps .
1/23
Why not remove the spark plug during spark testing to mitigate shaking since there would be no compression?
Please do more videos!
Joe, excellent video. Do you know the purpose of the 3rd point off to the side?
When adjusting the spark length to indicate the coil power condition if moved too far the spark will jump to the third point . On two point testers it may seek ground back into the module possibly shorting the module out .
1/23
the pet 4000 3 point spark tester used in the video can be pruchased through a RedMax dealer the part number is 501976401
redmax is about $20.00 + more that the pet
Sir please make more videos
where do you get one of these testers?
R