Thanks for your videos Justin! I’ve been watching them a lot recently since I downloaded Fusion 360 about a week ago to get back into some 3D modeling projects, and they’re super helpful!!!
How did you do a diameter dimension from the side? As in the 1.5 and 1.35 diameter measurements at 1:19s. I'm trying to show the diameters of the various parts of a watch case cross section and I can't see a way to do it in Fusion 360
Do you have a video on how to fully dimension a sketch? I know how to tell when it is fully constrained, but don’t know which dimensions to take to get me there
Hi everyone! Let me know if you have any other dimensioning tips for Fusion 360 in the comments below! :)
The best channel about Fusion 360. Clear, pin point explanation, no nonsense. Great work, my admirations!
Thanks for your videos Justin! I’ve been watching them a lot recently since I downloaded Fusion 360 about a week ago to get back into some 3D modeling projects, and they’re super helpful!!!
Thanks! Always wondered how you could align dimensions.
How did you do a diameter dimension from the side? As in the 1.5 and 1.35 diameter measurements at 1:19s. I'm trying to show the diameters of the various parts of a watch case cross section and I can't see a way to do it in Fusion 360
nice Video ! Thanks. Is it possible to change the side of the dimension if there is no space in between the lines or on on side ?
THX
Do you have a video on how to fully dimension a sketch? I know how to tell when it is fully constrained, but don’t know which dimensions to take to get me there
How do you dimension on 3D models
THIS is really time saving. Thanks a zillion.
Thanks for watching!
Wauw! This is great!! Tnx for the vid