CF Moto 450 MT offroad suspension Setup in 3 minutes

My 450MT came with the hard suspension factory set-up. Almost nothing worked off-road and every unevenness even on the road was noticeable, sometimes throwing me in the air!
With just a few clicks I achieved the ideal setting for me. The motorcycle now is coasting ahead easily over obstacles without bumping around, even on gravel and harder bumps, and gives me a very safe feeling. The result is impressive and I can hardly wait until the break-in period is over and I can use the full engine performance.
The settings at the end of the film are made based on the factory settings. The factory setting is exactly in the middle at 10 out of 20 possible clicks. Starting from this, go counterclockwise both at the fork and at the rear. Of course, this will probably have different values ​​for you, depending on the rider's weight, total payload or the speed at which you are traveling.
The setting in the video works quite well for my skill level and weight.
For fine-tuning, it makes sense to drive the same known route more often with different settings and make small changes.
Also check manual for basic information pages 132-139