UJK Technology Compact Lock Jig

This Adjustable Lock Jig is made of 12mm thick High Pressure Laminate, dimensionally stable and with a lifetime guarantee never to warp.
It is fully adjustable for lock faceplates up to 175mm in length.
The jig includes interchangeable templates to cut mortice and faceplate recesses for the most popular door sash, mortice and deadlock sizes: two faceplate templates for 25.4mm(1") and 22.5mm(7/8") wide lock plates and templates for 19mm(3/4") and 16mm(5/8") wide lock bodies. These interchangeable templates have keyhole slots for quick and easy template changing.
Set-up is easy, you just need to mark the centre line of the door and the centre line for the lock. The mortice will be square to the door ensuring the parts are square and making it easier to fit the handles.
It is suitable for doors up to 58mm(2.1/4") thick. You will require a 1/2" router with a 12.7mm(1/2") straight cutter (long reach if possible) and a 16mm guide bush. In addition, two clamps to hold the jig in place and a screwdriver to adjust the settings.
to purchase: www.axminster.c...

[@TheLennon1250]

The people complaining that they could chop it in by hand quicker because how long it takes to set up😂. When you have 20 doors to do. Give me this any day.

[@sarfrazali1302]

It's wonderful idea good job 👌 so easy and simple 👍👍👍

[@gm2741]

So hinge jig uses a 12mm cutter and lock jig uses a 12.7mm cutter. Why not make them to use same size cutter?

[@jameswatcham209]

How does this jig work if youve hung your door correctly and put a leading edge on the closing side of it?? The door used in the demo vid still had the factory square edge.

[@mitch3683]

Used to get £3.50 to complete this with handles fitted using swing brace, auger bit and chisel in the 80’s😏🇬🇧#backintheday

[@proteus1]

Why not make a longer cutter. UJK to the rescue.

[@ThekiBoran]

What if the router bit is not centered in the guide bushing?

[@tankcarpenter5496]

£100 says I could complete a lock faster by hand. You still need to fit the striking plate/keep and handle!

[@leetomlee7265]

Do you have a hinges template like that? The lock jig work looks clean and neat like a shop's work.

[@axminster]

Hi, please look at www.axminster.co.uk/ujk-technology-hinge-jig-with-clamp-plate-101504?sel=101504 Kind regards Tracey

[@JohnUk65]

why use this with all the setup time when you can use this>>Souber DBB Mortice Lock Fitting Jig!! with no fuss ?

[@davefields2209]

Looks like a nice jig but too slow

[@kevinchamberlain7928]

hassle-bound.

[@shamailsyed439]

abit time consuming

[@Pimpasxx]

What you gonna do with deep nasty scratch?