Place Using Interface greyed out? After clicking the Assemble command and selecting a component, the Place Using Interface is greyed out. I'm using Windchill and Creo 7.0 Any ideas?
I was just reading about this and ended up here. I got this from my help search The autoplace_single_comp configuration option must be set to yes to enable automatic drag-and-drop placement of components. And there might be other settings that need tweaking as well. And you need interfaces in both the assembly and the component perhaps?
Well, it can be done with assemblies. A subassembly is just an assembly inside of another assembly. There’s a reason they call it “Component Interfaces” and not “Part Interfaces.”
Thank you Dave
Very efficient
Thanks, Nabeel!
Place Using Interface greyed out? After clicking the Assemble command and selecting a component, the Place Using Interface is greyed out. I'm using Windchill and Creo 7.0 Any ideas?
I was just reading about this and ended up here. I got this from my help search
The autoplace_single_comp configuration option must be set to yes to enable automatic drag-and-drop placement of components.
And there might be other settings that need tweaking as well. And you need interfaces in both the assembly and the component perhaps?
Can this be done with sub assemblies?
Well, it can be done with assemblies. A subassembly is just an assembly inside of another assembly. There’s a reason they call it “Component Interfaces” and not “Part Interfaces.”