Steve: Was trying to get the SNMP node to read a device via SNMP V3 using a IPV6 address. Works fine with IPV6. Any pointers on how to use NodeRed to interact with IPV6 devices? Is there a trick to formatting the address in flows? Thanks in advance!
Hi steve, wonderful explanantion on this, instead of sent data, what if one wanted to request data(fetch data) example the payload or deice's data from the iot device,from actility into node-red. is there any guideline o n how to do that?
Nice video!! Pls dont stop making these videos
Grrrreat Video !
Thanks a lot, Sir.
Steve: Was trying to get the SNMP node to read a device via SNMP V3 using a IPV6 address. Works fine with IPV6. Any pointers on how to use NodeRed to interact with IPV6 devices? Is there a trick to formatting the address in flows? Thanks in advance!
Hi
Not looked at it but I will what nodes are you using/ wanting to use.
Rgds
Steve.
Hi steve, wonderful explanantion on this, instead of sent data, what if one wanted to request data(fetch data) example the payload or deice's data from the iot device,from actility into node-red. is there any guideline o n how to do that?
Hi
That should be covered in these videos
ruclips.net/video/cicTw4SEdxk/видео.html
ruclips.net/video/nz0KQWtcgIc/видео.html
Rgds
steve
what if the data api endpiont only receives content type of "application/x-www-form-urlencoded"
You can change the content type in the request header but haven't tried it with thingsboard API.
Rgds
Steve