Question on your Rhino ramps. I have always drove up on them front end only. Any different driving reversing up on the rear tires? Need to check my transmission oil level. I have the 16,000 Rhino ramps. Hope they fit 275 tires.
Taotao Inpa Cable with Switch FT232RL K+D CAN USB Interface Cable Car Ediabas K+ Dcan USB OBD2 OBDii Diagnostic Scanner for BMW www.amazon.com/dp/B07L498NGZ/ref=cm_sw_r_cp_api_glt_fabc_JN5G3208XBKMEGEWMW7M
@@williefast99 could you give me a quick run down on how you fixed it. I switched transmissions and it will rarely work like it should before going to trans. fail safe mode. I been riding it like this since November
@@williefast99 how could you tell it wasn’t going into lockup? I think mine has the same common seal leak but it’s low on fluid and I plan to fill it up and see if it fixes anything.
Ok nah bro. You filled it when it was too hot first and youre instructing to fill it after measuring it cold. A simple zip thru the gears with ensure its distributed properly as you fill it but the whole thing should be simplly one "safe" warm reading.
Thanks for the sharing of the the video. Your carpet is dirty! Pull out your seats and do a real good vacuum and shampoo! I don't mean to criticize and I do apologize for my doing so; however, I could not live with my baby having dirty interior. I am a total freak when it comes to my Bimmer's health and hygiene. I keep my baby running and looking like brand new. As a matter of fact, I have an appointment in June to get her paint completely stripped down to bare metal and repainted the same as factory color, topcoat and whatever coats the factory applies to the body.
Авто/Мото
Thanks for the demo
I can👃 it from here. Thanks for the tips!
Question on your Rhino ramps. I have always drove up on them front end only. Any different driving reversing up on the rear tires? Need to check my transmission oil level. I have the 16,000 Rhino ramps. Hope they fit 275 tires.
No different reversing on them. Shouldn’t matter for checking trans. I
Thanks for the video! Would you please link the exact cable you used for INPA to read your car's data? Thank you
Taotao Inpa Cable with Switch FT232RL K+D CAN USB Interface Cable Car Ediabas K+ Dcan USB OBD2 OBDii Diagnostic Scanner for BMW www.amazon.com/dp/B07L498NGZ/ref=cm_sw_r_cp_api_glt_fabc_JN5G3208XBKMEGEWMW7M
@@williefast99 Thank you 😊
why don't you just go for drive to heat it up instead of idling?
What was wrong with the torque converter?
It had a bad seal and wouldn’t go into lockup.
@@williefast99 could you give me a quick run down on how you fixed it. I switched transmissions and it will rarely work like it should before going to trans. fail safe mode. I been riding it like this since November
@@jojo-vc6qe I installed the Transgo pressure regulator and replaced the bad torque converter. Mine wasn’t going into fail safe mode though.
@@williefast99 how could you tell it wasn’t going into lockup? I think mine has the same common seal leak but it’s low on fluid and I plan to fill it up and see if it fixes anything.
@@anthonywilliams1616 it should run 2750rpms at 80mph. If you’re at 3000 it’s not locking up
What size socket
8mm
@@williefast99 thanks
@@williefast99 is that a hex socket.
On my Tranny it’s a T50 🤷🏾♂️
@@dgod6715yes
Ok nah bro. You filled it when it was too hot first and youre instructing to fill it after measuring it cold. A simple zip thru the gears with ensure its distributed properly as you fill it but the whole thing should be simplly one "safe" warm reading.
Sounds like you don’t know what you’re talking about.
Thanks for the sharing of the the video. Your carpet is dirty! Pull out your seats and do a real good vacuum and shampoo! I don't mean to criticize and I do apologize for my doing so; however, I could not live with my baby having dirty interior. I am a total freak when it comes to my Bimmer's health and hygiene. I keep my baby running and looking like brand new. As a matter of fact, I have an appointment in June to get her paint completely stripped down to bare metal and repainted the same as factory color, topcoat and whatever coats the factory applies to the body.
Haha. I will clean it one of these days. Seems like I spill my coffee at least once a month in this thing.