Thanks for video! Can you clarify real requirements for compressed air. As I know, HAAS doesn’t required Refrigerated dryers. But after compressor , air has 100% humidity. It will definitely cause water deposit in the air system. But we may not notice water in air gun. I never notice any signs of water in my TM-2p, but after 4 years of using I found doors locks completely corroded. Probably , it would be honest to make a requirement for air dryers before machines.
Hi! I am in Brazil, i'm sorry for my bad English. please talk about protection telescopic. procedures mounting and disassembly and also as the operator must keep it. Have VF4SS.
Can you direct me towards the brand and type of the reddish-brown pipe sealant you use? I see it used everywhere on my machine and would like to adopt it for the piping of our air system. Thanks!
Sadly this video is missing all the trouble shooting of components supplied with compressed air. When our TM1P (2010) is on significant amounts of air leaks out of the spindle housing both with tool in and tool out you can feel it blowing. This video really needs trouble shooting that is not due to faulty pneumatic components.
The TM-2P i run seems to randomly give me "Alarm 830" even though it runs perfectly for half the day. Any input into why it might be doing this and what steps I should take to fix it.
That is very informative and so useful, thanks to Haas that has made this videos available.
Quality videos from a quality company
Very informative, and well done video! Thanks, Haas!
Really good informational video
Great job
Thank you for sharing
Thanks for video! Can you clarify real requirements for compressed air. As I know, HAAS doesn’t required Refrigerated dryers. But after compressor , air has 100% humidity. It will definitely cause water deposit in the air system. But we may not notice water in air gun. I never notice any signs of water in my TM-2p, but after 4 years of using I found doors locks completely corroded.
Probably , it would be honest to make a requirement for air dryers before machines.
Hi! I am in Brazil, i'm sorry for my bad English. please talk about protection telescopic. procedures mounting and disassembly and also as the operator must keep it.
Have VF4SS.
hi if you have haas vf4
Can you direct me towards the brand and type of the reddish-brown pipe sealant you use? I see it used everywhere on my machine and would like to adopt it for the piping of our air system. Thanks!
Hi, I have a Haas VF2 machining center from 2002. I get alarm 628, how can I solve this problem?
On a VF3 mill. I have alarm 130 tool unclamped. Where can I find what is the exhaust muffler? Is that located in that same panel?
Sadly this video is missing all the trouble shooting of components supplied with compressed air.
When our TM1P (2010) is on significant amounts of air leaks out of the spindle housing both with tool in and tool out you can feel it blowing.
This video really needs trouble shooting that is not due to faulty pneumatic components.
I cannot fin any info on how to fix an error where the machine is not recognizing some of the pockets
Emissions
The TM-2P i run seems to randomly give me "Alarm 830" even though it runs perfectly for half the day. Any input into why it might be doing this and what steps I should take to fix it.
Order ferrite filter from Haas and put it on your Z axis encoder cable on the processor board.
What's 830? Might be a loss of air, or the valve shuddering.